Viewing all customer Discussions for:

Other

One window has only a broken handle to the crank. The other window the crank isn't attached to the window.

I need 24 of them.

Hi, I need a new set of rollers for our sliding door. Hoping you guys have them. I've uploaded the image with identification sticker. Thanks, Richard

gold track 6ft

Hi, need a coil balance like this one. Do you have this in stock? Thank you, Peter

I need 2 pairs of 30" inch long balances

The interior plate that slides up and down over the locks on the wall side has broken and slid down into the door frame. I need the plate

I'm looking for a replacement part: Vinyl glazing bead for Insulate industries series 3000/3001 window.

hello i need these 2 parts for a window. Can you tell me if you have them in stock thank you

The attached pics show inside and outside of patio door with mortised lock

I need the entire setup for 4 windows including the shoe set and bars that's rotted. Thanks

Please refer to the attached pictures and advise me if your 28" Series 385 channel balances would have the correct top and shoe for my part. If so, I understand the part is currently unavailable. It's appreciated if you have estimate time of availability. Thank you

This is marked as a Truth #31761A but every potential source that I've found doe NOT have the offset mounting tabs. According to Truth's literature, the wheels should be nylon because I suspect the track is aluminum. Mounting hole spacing is 5-3/4", max body width is 11/16".

What part do I order?

The piece is the bottom sill of a wooden slider window about 46.5" wide x 41.5" high as shown in the two attached pictures; The first photo shows the right side near the wooden sliders and the second photo shows the left corner of the sill. The plastic sill is 44 3/4 inches long and 3 1/8 inches wi ... (cont.)

Will part # 90-253 work to replace a broken Atrium window lock cover?

Measured 27" long, 16/9" width, 5/8 deep, the mark is 2630 Thanks

Hello, can you confirm that I have found the right part for my windows. I will need 2 rights and 2 lefts. https://www.swisco.com/Andersen-Window-Crank-4-1_2-inch/pd/Casement-Window-Replacement-Operators/39-146 Thanks, David.

Hi, hope you can help me. Have Stanley patio doors and need wheel assemblies. Housing is brass and wheels are plastic. Am hoping I can find steel rollers with ball bearings. This is the 2nd time I have to replace these in just a couple of years. Overall length is 4 1/4" from end of housing to edge o ... (cont.)

There are 3 photos, one showing the broken coil spring on our vinyl window, one showing the unbroken spring and the third showing that we do not have a notch to slide the parts in and out. The shoe has the number 4 on it, so that must be the size. I saw one of your videos showing you can use a ja ... (cont.)