Viewing all customer Discussions for:

Other

My old spiral balances have a green tip and measure 33 inches long and 5/8 inches. I don't see a green tip spiral balance for this measurement on your website. Which color would I substitute for my 1996 Alcoa brand windows? My spiral balances look like the Series 600 balances on your website. Thank ... (cont.)

Hi good morning I want to know if you can find me a replacement hinges It has HAFELE stamped on it. Thank you

I am sure from reading the post on your website about this part not avail anymore. I am curious if any other kind on hardware can installed instead if the existing one which can make the window fully functional. Please advise

I have several sliding patio doors with the 82-005. I don't need the exterior flat handle. Do you have a replacement matching handle to the interior handle that could be replaced so both handles to make it easier to open?

We have a 1974 home with double bi-fold doors on closets.They are still nice enough but the years have elongated the wood in the bottoms of two doors, and dang, I've lost one of the pivot bolts, as in pictures. Can you help me find another one of these? And perhaps the long T-nuts?Loyal ... (cont.)

It' has pado stamped on it. Can I get a replacement one with a strike plate?

My lever to lock the door from the inside has broken. I'm pretty sure all I need is the gasket that holds the lever in place.

There are a couple of markings on the part (27B and Amesbury.com).

To Whom It May Concern, I am trying to locate a replacement left hinge dual arm roto operator and casement crank for an Anderson Silver line casement from around 2007. The connection point for the casement crank is stripped out and the casement crank does not stay in anymore and the internal mecha ... (cont.)

I'm looking for exact this sliding glass door handle but I can replace new key

Would like to have a part number which includes the following features: 21 inches in length, 1/2 width, and information shown in the photo. Thanks! Mike Kao

On one small window Balance its printed 2740F and on another high windows its printed 3420. Both balances are 28" long, the metal part.

Hello, I am trying to find the correct replacement latches for my tilt windows. The manufacturer was Le-Al-Co and they are no longer in business. The latch is surface-mounted, and measures 21/8 X 3/4 inches. I have attached a couple of photos. Thanks much, Vanessa

Hello Swisco group, Do you have the Leigh hanging closet replacement rollers? It has a front dimension of 1 3/8" and a rear dimension of 3/4". I believe the part may be number 77-28287. thank you, Linda

I live in Florida and have a second home in Boyertown, PA. I need to replace and repair the window's in the home. I did not locate any markings other than down on the face of the part. I will be in PA. on Nov. 1st. and leave on Nov. 5th. We are real close to Philadelphia and your location. I spoke w ... (cont.)

Manufacture is not identified

this part from polybau vinyl window

Good afternoon - trying to identify and purchase this part from my double hung / tilt windows. I was told these are Peachtree windows, but cannot find this part nor do the replacement parts look like the Peachtree parts I can find. This plastic piece sits inside the plastic channel with the spring ... (cont.)

Anderson door latch the opposite side as the pictures indicate.

Older door, hard to find.