Viewing all customer Discussions for:

Other

I am interested in finding out about product #58-127...We have double doors at my job and the felt weatherstripping is missing leaving a gap between them leaving all the cold air to come in..We cut a piece off,and the measurements are 3/16 x 1/4..I want a good seal,and was wondering if this is the s ... (cont.)

I'm looking for milgard part number ws6919bbuwh. Do you have something like this

I would like to replace both tracks and upper and lower brackets on my bi-folds. I have four panels for my 5 ft. Opening. The doors are very heavy as they are 6-panel oak. I will attempt to email a picture.

I have CertainTeed casement windows. I need a hinge assembly.

I have an existing single hung non tilt window with a channel balance with one marking of 22 9 BSI RC. The window manufacturer is CSW Model - 3500 SH. The length is 23" NOT including the plastic pieces. What option do you recommend?

Hello, I need to replace the entire locking mechanism on my pella storm door. The registration number on the door is 022107905613071. Hopefully you can help me out. the finish is polished brass

Parts list for window shows: "Pile Weather Strip with Center Fin A)27018758 WHWF", then to the right of this is a box with the following info: "Configured Number (S 4-02) and C982041". The windows were installed in our house which was built in 2004. The pile is pretty smashed down and looks to be co ... (cont.)

need 2 of these balances on champion vinyl window

Sirs: Do you have a replacement for this type of pivot block? Thanks, Eric

Need replacement for window balancing rod. Total length from end of plastic to end of plastic is 28". From end of metal to metal is 27". Only identifying stamp is B.S.I 2630V

I would like to Buy tw

the plastic tabs that hold the window frame in the rough opening of a basement window. You pull out on the tabs to take the entire window out of the opening. I'M TRYING TO FIND REPLACEMENTS SINCE A CONTRACTOR BROKE THESE WHILE REMOVING THE WINDOW.

My slider: pPG Herculite K HP door needs a new indoor handle and the lock does not work. What would you recommend?

I have a broken cmec h storm door interior handle part number 34141. Where do I find a replacement?

standard swinging door weather seal EXCEPT, instead of the usual 1/8 kerfed insert, this insert is thick and round, about 1/4 inch! Any suggestions for replacement??

i am trying find stanley window spring bolt any body knows similar product or where to find stanley window spring bolt. stanley no longer makes this part

The steel blade is 21". The marker is 2030, followed by the side BS1 VP? I need 4 of these. I also need 18" as well (qty 2).

Hi interested in finding a few parts= wheels for peachtree patio sliding door ,also have the kind of windows same style as patio doors just much smaller , patio door only has 1 slider the other door is stationary =only thing i found on the glass= TRUETEMP SAF-ANSI Z971-1972 =3/16U SGCC 28 ASG ... (cont.)

Looking for Bottom seal for Builder Grade Champion window bottom sash seal

Please confirm that your Product Code: 55-180-6 is the most likely match for my application. Attached is a cross-section photo and dimensions diagram for the vinyl glazing I need to replace. Note: the dimensions are the closest approximation I could get with my calipers on the slightly deformed ol ... (cont.)