Viewing all customer Discussions for:

Other

I'm trying to find a replacement part for the locking mechanism inside my sliding glass door. Picture included above.

I have one window that is completely separated from the mechanism on each side of the window that assists the window open and close smoothly. I'd like to replace the components that are on either side of the window. I uploaded a few pics of the parts that were visible. Not sure if there are addition ... (cont.)

I have a two-pane window above my kitchen sink that has a crank mechanism on each window. I would like to replace the two crank mechanisms. I uploaded some pictures.

Crank/gear window handle

Hello..wondering if you could assist with what part I should order from you.

Patio door handle maybe 7 in long each screw is 3 mm from the edge It has a slide in the back to open the clasp the clasp falls down on the frame I want a handle and I want to lock on the other side they can lock an open with a key.

Need replacement for this pivot, also there is no opening to remove it like you show on your videos

Thank you.

3inch and 3/4 from hole to hole

I have this style crossbow balance but the plastic pieces are all broke and the gray rod slides down inside the spring. How can I tell which one I need. The windows are 58 inches tall, if that helps. Thank you.

Hello, I need some help identifying this window crank. The arms are ~12" long. The handle assembly has some stripped parts in it that are preventing it from opening and closing properly.

The windows are Nami. Code: Hil-280-3 Spec: NFRC Series: CVDH Mst: 280-M-001 NFRC-100

long arm is 9"

There is a main "Entry Gard" arm. But there is a smaller arm at the top of casement window and at the bottom. The top is fine. The problem is that the home sat for 5 years and the bottom small arm rusted off. #6799 in the pictures. Its a 6" piece that connects to a screwed in piece on the botto ... (cont.)

I measured #20810 at 4 7/16 main arm 9 3/8 large numbers on part R30842. I could reuse the old crank and cover

On the right "arm" the hinge point "rivet" is broken/missing. I need a whole new assembly. Which part is it I need to purchase/order?

Identifying #R30842 on arm close to crank #20810 on small arm

Any info would be appreciated. Thank you

Trying to identify the part and can't find an exact match, I'm thinking they have changed slightly over 10 years

I need 2 pivot lock shoes with springs.