Viewing all customer Discussions for:

Other

This is a smallish approximately 1 inch in length part that the lock would latch into made of plastic

I am on the hunt for a vintage mortise lockset for a wrought iron door and this is what the mortise looks like & I do not know the brand that it is but the key is a Yale Y1.

As you can see by the attached pics, this unit has broken and needs to be replaced. Not sure of the window manufacturer but the unit has "L10" marked on it. That's the only marking. Part of the coil spring is still inside the unit showing that it snapped in half. Do you have this replacement part? ... (cont.)

Hi there, I wanted to let you know about an issue I've encountered with the patio door. Unfortunately, the key broke inside the latch, and the inner golden handle support also got damaged due to some forceful pulling. I'm hoping to resolve this myself. If I can find the golden part and the exact loc ... (cont.)

Channel is 34 inches long. Spring is 20 inches long

Hello, I am looking for 2 of these brackets / clips. Thanks. I also have another request I just submitted for snap in glazing.

Is there anyway to determine the needed length of the channel balance other than measuring it? The sash is 29" high. The Anderson window is original to a home built in 2000. Getting to the window to tilt it in and measure it is difficult.ThanksScott

I have two windows where the upper sashes have damaged balance springs

Name on hinge is HEPLN

I'm looking for a replacement sliding glass door handle and lock.

There are two markings in the original balances: C97 6#23384 and 11600-17. can you tell me what the correct balance would be for replacement? And if there are different part numbers for left and right?

Hi, I would like your assistance in identifying this replacement part to tilt open the windows. Also when installed are they removable to use on more than one window, or should I buy enough for all the windows (ie do the snap in and stay put)? They are 2 in long, about 7/8 in wide and the prongs are ... (cont.)

Hi. I am looking for replacement parts for the attached photos. This is the only information that I could find on the pieces. Truth Entry Gard Part No. 4.840.075.

House built in 82'. I have these window cranks that need replacing. how can you be sure to ensure you're getting the right arms or are they even available?

This is a Willmar window purchased in 1993. The arm says it is truth entry guard and a serial number 20910A

The latch system measures 11.75" top to bottom. The screw hole pattern for the keeper measures 9.75" top to bottom. I am looking to replace the latch keeper. Needs to be raised, not flat mount as the door casing is 1.5" deep and 1 5/8" wide. Can you assist?

Coil snapped on both sides of a window, looking for the right replacement part. Attached are photos, the coil stamp is #10, the white casing has a #8. The bottom weight dimension are 0.5 inches wide and 1.25 inches depth.

Good morning, I'm looking to replace this crank due to the gears are wearing, and the window no longer opens. I can't figure out which plate I need. Thx

Tilt latch

I have Simonton 6500 series double hung coil that I cannot read the weight off of. The window is 26 1/2" wide and 13" high measuring the glass, 30 1/2" and 17" high including the frame but inside the track, Please advice what weight coil(s) we need, THANK YOU for the great video!!! I had spent an h ... (cont.)