Viewing all customer Discussions for:

Other

Hello, I am attaching pictures of my current balance channels. One channel is shorter than the other for some reason. 29 inches vs 30 inches I have few windows with the same problem. Thank you for your help, Redjem

Please help me getting the correct replacement

I'm looking for the metal glide that mounts to the bottom of the center of the drawer. It's 15 by 1 1/4. if you have the glide it sits on, i;ll take 1 too/

The tilt latches on several of my windows are broken. I would like to replace them with original parts, but I can only find one repair company in Ocean County, NJ, and they aren't very good at returning calls. Since I'm not very handy, I don't want to take the windows apart myself.I noticed you have ... (cont.)

These 2 piece retainers hold the exterior mounted storm window/screen to the window frame. What might you have that is similar?

My Thermal Gard casement window has a part that broke. It looks like some type of stabilizer bar. Photos are attached. Can you please let me know which parts I need to fix this issue?

Basically, I found the 26-393 - Tilt Latch Pair which works perfect, except it is 4-5 mm too short in the body length portion. I would love to exchange these for something that works better.

Hello, looking for part # or #'s for replacement parts pivot hinge set. Primarily bottom. Threshold has broken bolts and look a like going to baba pain to remove and repair right. Plan is hoping to replace bottom pivot piece with bearing on door to get by until lease is up. Douglas ... (cont.)

Hello, I am getting very frustrated due to Simonton. I have a customer who needs Single Hung balancers swapped out in one window. Never did it before for this window, but feel I could if I have instructions. I do not have cam measurements, but new cams are needed, 2 pivot pins and balances for l ... (cont.)

Sir:Can you help locate this roller? Marked Kilian Syracuse NY. If you can provide them I need a total of eight (two screens). Please advise. Thanks!Chris

Two numbers on the slider bar 32062 31861

MY PIVOT BAR IS 1 3/4 AND THE ONE I RECEIVED FROM YOU IS 2 3/8. WILL IT WORK?

Hello, I'm looking for some help identifying a drawer slide. It is a wooden drawer slide that has a width of 3/4 in. and a height of 2 inches. The plastic hanger bracket is what broke and mounts to the end of the drawer slide. I need the plastic receiver, which is a three-quarter by three-quarter sq ... (cont.)

Shower Door Rollers/Runners/Spares/Grooved Wheels for rv round shower

What is the part

Kindly assist with ID of my Channel Bal, I think it is 390?Channel Bal Specs/Info: Numbers ShownStamped on Balancer: 27CLength: 27 15/16 In (or 28 In)Width: 5/8 In (or 9/16, Aka 1/2 In)Foot Dept: 1 1/8 In?Note: I was not sure how to measure this, see picsWindow Brand: Alenco (Condo Built in 1 ... (cont.)

Can you help me with this? Ray Ciccolilli

Hello, I'm looking to replace my sliding glass door handle, (both sides). I hope this picture will help!

The label on the item is 86 14-4 CAS CMC 7. The channel is 15" long

the only numbers on the balance are 24 3.RNBS1 TH the metal measure 263/4 inches there is no clip to hook cord to? need to order two balances for my window sash. want to order the correct balance to fix my window