Viewing all customer Discussions for:

Other

How to know what series to order?

no part numbers or manufacturer seen. I included a photo of the sash where it comes out in one part from the face and one part from the opposite side. I just need to make sure I get the right part

3/4 inch wide 11/16 from end to first installation screw 1 13/16 inches from hole to hole 2 15/16 total length Need 4 sets plz.

Hello, we have two sliding patio doors. The first picture functions correctly with a pin intact. The 2nd/3rd picture is from the non-functioning patio door with the pin broken off and a DIY solution in place. Is there a replacement for the pin or the housing. Your assistance is appreciated. - S ... (cont.)

Hi, I believe this is a series 380 channel balance. The channel itself is 25" long. The marking is very difficult to read, but it looks like it says "25 3(degrees symbol) KO CALDWELL".

The lower part of the window weighs about 14.5 lbs, and its vertical length is 20 inches. Please advise me of the part size that I have to purchase. Thank you.

The house was built in 2000 and it is vinyl window. the windwon can't stay open anymore. The window balance is broken and stuck, it needs to be replaced

The drawer glide plastic piece is broken. A piece of wood runs through it.

Hi I havea MI window and door 3500 SH 12675845.4. The window doesn't stay open. From what I'm learning, the shoe plastic is broken. The ?pivot piece (screw thing) is stuck underneath the frame of the window so I think what I want to replace is the plastic part. I have no idea how to find this part o ... (cont.)

Trying to identify this morose and need a replacement

This guide catch is used in a bathroom drawers in a 2008 manufactured home triple wide.

Tilt Window system - The metal tube is 3/8" x 28 1/2" inches. Do I select 28 or 29 inch?

I need a part number!

Its an older milgard vinyl sliding door. Maybe circa 2004-2008? Milgard is not helpful.

2 1/4" hole distance 5/8" projection lock

Please help me find a replacement. The measurement from center screw to center screw is 2 and 1/4 inches.

The roller is broke as well as the lock

try to find wheels or rollers that not make the aluminum track black and stain my drapes.

I am looking for a component of the channel balance system to go with the S385-21 parts i just ordered. This part screws into the window near the top of the channel. Is it called the top sash guide? Can you recommend a good replacement for it please?

Looking for a pivot bar for my Grandview double hung window. Only marking on the bar is a 8.