Viewing all customer Discussions for:

Other

The door has a tag that says "Citation"

We are looking for a replacement channel balance for our windows. the whole thing is about 26 inches long and 5/8 inch wide and 5/8 inch deep. Here are the pictures I've taken. What is a good replacement for this part? Thanks.

The length of the plastic housing is 1.5 inches. The iPhone camera makes it look shorter than it is. I didn't see anything on your website that matches but I'm hoping you can identify and recommend a replacement.

I have the original crank for a VELUX VS opening skylight, but the blind keeps it from being able to work. I need an approximately 8" extension or a T-handle crank for this window. The part that inserts into the window is 5/16"hex. The part that inserts into the crank handle is 13mm. ... (cont.)

I need two glides for my sliding window. The hole it goes into on the bottom of the window is 1 5/8" by 3/8".

My name is Sue. I can't find same pivot lock shoe from all your products. Please help to find correct parts that I can buy. thanks a lot.

The windows were purchased and installed by Thermal Quality Windows and Doors. The company replaced a few, but not the same or were they satisfactory. Over the years about 4 have broken like the one pictured. Please see the photos for markings. Thank you!

Good Afternoon, I am looking to purchase some window balances for my MI window Series 3500 I'm looking for both left and right balances, Inv Coil Balance 3060EQ Right and Lefts. Any chance I can get a quote for a dozen of these balances? I have attached an image of the balances I have in the wind ... (cont.)

I need plastic screen corners. MY existing ones have a 782 number on them. I need 2 regular ones and 2 with a stop.

Our kitchen LH and RH locks look like these. Both have now had the "flanged" washers fall off, this being the flanged washer like that in fourth picture above in Dearborn Hts, Michigan's inquiry of Apr 10, 2023. Having the washer fall off is the only thing wrong with mechanism. How do we get it re ... (cont.)

Hello, I'm not sure how to measure this track but here are a few photos. Might you have any suggestions for me? Thank you

Hi, I need to replace this part on a single hung tilt in window. It comes in left and right. Do you have a replacement part #. It attaches to the bottom of the window. Thanks

need to identify correct pivot bar and shoe replacements. I am a full time skilled handyman with a few prior replacements of this nature. see attached photos thanks

Don`t know how to remove the tilt latch. Will need 4 of them and would like a new screen if possible. windows came from Home Depot about 2010.

Steel Cabinets from 1972. Drawer wheels are plastic, possibly nylon, outside diameter 15/16 inches, Wheel rolling flat surface is 1/4 inch wide and offset from steel surface by 1/8 inch, mounted into a pop in hole, and hole diameter is approx 5/16 inches diameter. The wheel rotates on a plastic cen ... (cont.)

I'm looking for a replacement for this crank handle can you tell me which one I need? It says 2108 inside the handle and has a pin on each side

Hi Friends, Can you help with this? I really need help with a few details for these replacement parts. Thank you. Kindly, Jeremy

Can you please help me identify what channel balancer I need? This is from a Milgard window. The only information I can find on it is 13 4 PM. Between the 4 and the PM going across in the opposite direction, I see what could be ISF or TSF Or IS8 (very hard to see).

I'm looking to see if someone can help me identify this roller assembly Thank you

Looking for 2 rollers for patio slider.