Viewing all customer Discussions for:

Other

Need help finding a replacement for this window balance. The length is 25 3/4.

The have two windows with these hinges labelled Truth 30905. The attached image is of the lower hinge attached on the right, but I actually need both the upper and lower hinges for the window with the hinge attached on the LEFT hand side. The house is about 30 years old and the sashes are wood. ... (cont.)

Can I replace the locking latch or do I need to replace entire unit? Thank you

What do you have that is close to this? I can make a comparison from a picture, you should be able to. The original stuff is so shriveled up, a photo of that would be less clear than the drawing.

this clip is has fastener to the glass patio fixed door and the wall fixture. Don't know who manufactures this.

Patio lock replacement

4 rolls enough for 7 windows Have pictures.

Numbers on arms are - 41012 and 31876

Window guides for 1978 metal window single pain. Guides are at the bottom of the windows at both ends they look to be L shaped and slide into a grove on the side

Need new part!

I'm looking for these replacements parts for quaker windows. I have included pictures. Please advise if you have part numbers and where I can purchase them at. Thank you Mendy

Can you identify the roller part in the picture of a mirror sliding closet door.

The window doesn't stay up and I need help identifying the window balance part that I need to purchase

These are parts needed for a M I Window 9770 Series

Mirror sliding door hardware assembly needed

Hi I'm going to replace all the balances and tilt latches in my windows. I've added pics of the latches with measurements visible, hopefully that gives you what you need. For the balances, they are 28" long and 3/8" diameter. The sashes weigh 18 lbs. The original tips are all broken off or missing. ... (cont.)

I don't know what it's called but this holds the end of an arm that penetrates the window frame. The arm has a "pin" at the end that act as a pivot point , you can see how the part has a space for that I need two of them.

Hi, thankfully I was able to identify that it was your company that made this due to the stamp. I would like to order a replacement. the 3 photos attached are what are at the ends as well as the stamp. The plastic from the top of the pulley system is broken and the pin that held the very strong s ... (cont.)

Looking for a new latch for this door. The inside of the mechanism is broken.

Hi - the track cover was cut to install a dog door that is no longer there. I cannot locate any manufacturer information anywhere on the door. The track cover is 1" wide and just friction fits in the slot. Any help would be greatly appreciated!