Viewing all customer Discussions for:

Other

It came off of a sliding glass door.

Has a "A" stamped in the cup. It has the numbers 244.3493 stamped on the back side of the hinge piece that fastens to the inside cabinet side.

We are unable to remove the door to find actual part - this is a picture of the sticker on the door. The door is approximately 30 years old. Any help is greatly appreciated.

What rollers will work with your bottom roller track, item # 23-272. I purchased the track last month but the rollers attached to the bypass doors do not set in the grooves in the track. The bypass doors are wooden and about 1 1/2"thick and probably 20 yrs old. The closet features a bottom track ... (cont.)

Need casement operator and related parts, white handle/cover, guides. Pat. No 4,840,075. Made in USA

String broke

I have a project to renovate 117 townhouse units and I need to fix any window with balances that do not work. The balance has marks : BSI, RA and 28C. Your help would be greatly appreciated.

18" length. 1730 stamp no wings. Thanks

Number on this PAT5,353,548

can't figure out where to get replacements. Professional came out and said they couldn't help with either new rollers or a new door. Another said they could door a whole new door for $10k, but I'm hoping to find some specialty place that can make new rollers or let me know how to fix these ones. The ... (cont.)

Please see the attached picture of the side mount pivot we are looking for. Many of the dimensions match the 26-402 however as you can see ours only has one hole. Please let me know what is available. Thank you.

Need to replace broken latches. Mastic window

Metal length is 25 1/2", 9/16" channels. We will need 10 total

The shoes we ordered, 5# 210 roller-tilt single are 2.584 in long and .846 thick and the ones I need look identical but are 2.278 in long and .549 thick. They are both 1.25 wide. You carry a smaller one to match our Traco.

I can't find an 8" channel balance on your site. I've measured the metal part at exactly 8 inches and it is 9/16" wide. The number stamped on the side is 0710.

I am looking to replace this handle and cover and was wondering if there are other options that would fit this set up? I will need 30 of them and at $34 each we are talking real money. Please let me know if there is a, brushed aluminum, possibly, that might fit but could have a different profile. T ... (cont.)

Looked these in our local Do It Centers and Hardware stores, but NO match. Hope you can locate them. Thank you. Need 2.

Hello. I am looking for a new window handle, crank and 20-inch bar for a window on a 50+-year-old mobile home so that we can open and close the window. I prefer metal over plastic. What are my options? Slow learner.

I am pretty good at researching parts but this is a real mind bender. Apparently, it attaches to the balance rod? Any help is greatly appreciated!

Please help me find replacement parts. Thank you!AJ