Viewing all customer Discussions for:

Other

Sash weighs between 14-15 lbs. There is a patent number 5,353,548. One side is marked 3 or B with a marker.

Approximately 28 inches long. Can the shoe be replaced. If not, which part is the replacement and how do I determine which part to purchase? Thanks

I need a top hinge for a door purchased in 2001 from eagle dealer.

I have enclosed a picture of my old part and the incorrect part that I received. Hopefully, you can identify the correct part for me. Thank you for your effort. Dave

Rubber piece to keep drawer closed on chest of drawers

Hello, Looking to replace these parts. Thank you!

Hi, Our double hung windows have two balances on each side of the sash (so 4 spring balances total per sash). The pivot shoes on some of the sashes are broken. I've attached the best picture I can get without removing the sash (which I didn't want to do until I have the replacement parts in case I ... (cont.)

I'm looking for 2 windows locks. I'm located in Alberta Canada. Thanks in advance.

Hello I'm needing help replacing multipull parts for my sliding glass door. First I need a door handles for the inside and outside. The handle pins are 3 11/16" on center. I need a door lock. And last I also need to replace the weather stripping on the inside and the outside on the door. I hope the ... (cont.)

I seen you had another post with the same balance, said it needed to be made, I need 2 of these made please ASAP. Kenny

Wheel Diameter 1 1/2" Length 3 1/8" Height 1" Width 5/8" Metal Wheels

I need the piece that is on the bottom sash that you raise the window with

I want to fix the weatherstripping on the commercial windows. It seems that they are shrinking please help.

I need to get replacement parts for 4 casement windows 4 right top and bottom and 4 left top and bottom. could you please help me in selection the proper parts.

There are no markings but the part is on the bottom of the window pane as shown in pictures. The windows were Marvin windows probably manufactured early 80s. Marvin.com said they discontinued that part and advised me to check with you guys.

Need 2 of these for top and bottom of framed glass shower which has a encased rod.

These all broke at the top where they anchor into window frames. Thanks for your help

The bottom part is cracked, so the piece that turns with the window tilt falls out the bottom. There are no names, numbers, or markings on any of the pieces. Thank you for the help!

Do you have these available?

I need some Ellipse cranks with 13-1/2" arms per this photo. 3 pcs for LH casements in white.