Viewing all customer Discussions for:

Other

The pivot is very old and I don't see any part id on it. As you can see it in the pictures.

Our door is no longer opening or closing properly. I believe these rules need to be replaced.

I have 2 of these windows that close if you open them at all. They are sh-7500 by Lawson What do I need to provide you?

I have an older home probably mid 1980's with Peachtree Ariel casement windows. They have a 2 piece seal, one which mounts to the frame and one that mounts to the sash. I am attaching a few photos. Let me know if this is enough to recommend a replacement item.

Need two of these rollers

Top coil is a 6lb, bottom is a 7. Patent # is 5353548

I would like to order some replacement bottom weatherseal for my windows. Attached please find a picture of the window information and an image of an existing bottom weatherseal. Please let me know how this material is sold (lengths) and the cost. Thanks, Warren

Big window sash is 36" x 27 1/2", Small window sash is 36" x 17 1/2". Are there replacement balances available? Big sash: BL 23 10#31 10 85 Small sash: C19 6423 785

Small plastic piece that attaches slide for crank out pella window

window is 23 years old, I have the same problem in 3 windows, I have new spiral rods purchased from you a few years ago

Looking to replace bottom rubber seal on shower door. Bought 5/32 in. Tee style and it is too big.(see below). Mine is this style but much smaller (See picture below).

I have non tilt single hung window balance to be replaced. Stamp : 25 4 KQ CALDWELL Depth: 5/8" What is the appropriate replacement? Thanks, Jag

Hi! Just wanted to make sure I get the correct product before buying these for the whole house. "17 1" and "A 1" engraved on side. Unsure of weight rating. I was overly enthusiastic when removing the window and a plastic piece broke off but not sure if from this channel balance or the other one but ... (cont.)

Good evening. Can you help me identify three parts on my windows? I need to replace some spring balancers, the shoes, and some latches that release the window from the track. Thanks!

The ferrule acts as a bearing that the hole in the end of the arms attached to the bottom of the window rotate around. The ferrule is broken so the arm attachment point is loose and gets hung up on the broken ferrule and you can't get the window closed without a lot of manual manipulation. The scr ... (cont.)

Metal channel length is 37-11/16". Stamp says 37DS PK47L. Apparently BSI manufactured. See photo. No idea of window manufacturer, but probably made around 2003. I'd like to get four balances.

This is a ReliaBilt lock from a sliding glass door. There are no identifying marks on the hardware. It measures appx. 10" at longest points. There are 2 screw holes for handle hardware located at appx. 3" and 7" measuring from end-to-end. The interior lock and exterior (keyed) locks use the same int ... (cont.)

27 4 Caldwell IM (6 pcs) 24 4 Caldwell IM (4 pcs)

This is for a casement window. Unknown manufacturer. The sash lock shown is broken. in pic 3637 you can see the handle. In Pic 3641 and 3642 you can see where the handle is broke if you look closely.

i do not see any number or markings on the balance its 27 1/8 inch.how do I find the replacement? thanks