Viewing all customer Discussions for:

39-107 Truth Hardware Operator Cover

Looking for milgard casement window operators parts number stamped on #40753 on long arm, #31538A on short arm. The subject windows are approximately 25 to 30 years old and The operators were worn out. Please quote, thank you, Tom

Grayco window will allow me to crank out window but not crank it back in. there also appears to be a broken piece of black plastic that keeps window in track seen in image 8993. I think the sticker says k501305-01 grayco 09-3294B then size 27 5/8 by 53 1/4 bar10822 egress. Hard to read sticker ... (cont.)

I have a Windsor crank window. The window does not crank close. I am looking to replace this part in provided pictures that is between the handle and the crank. It looks like a metal washer or "c clamp" is broken. Are you able to provide this part without replacing the entire crank? Thank You! ... (cont.)

The handle as shown in photo fell off the wondow and I cannot find the missing bolt to reattach. Probably the cat rolled it under something. Can you please help with any needed replacement parts?

Hello Swisco, I have a Truth EntryGard operator wheel which is getting bound up on the track holes. The wheel spins freely, but the edge of the wheel is chewed up. I'm guessing the wheel is no longer the correct diameter and that's what's causing it to get bound up. I see the wheel is riveted on t ... (cont.)

see picture. part number stamped 30830

I believe the replacement would be the 39-107 Truth Hardware Operator Cover. Is that correct? The dimensions seem to be right/close. Can you identify the crank as well?

Windows are at least 35 years old. The cranks just seem to stop working. They might've been forced. Not sure what needs to be replaced. I have two right and two left opening casement windows that need to be fixed. Do you need to see the part/ arm that opens the window ThanksCary

I need 5 lefts and 5 rights.Thank you,Jim

Have broken crank, the turn screw pops out when the crank is turned. I believe I need 39-217, window opens to the left, the single arm is roughly 8.5" long. I also have multiple cranks like this, would like to replace the front of them with 39-107FK, is this compatible?

Truth 20810 operator

Hello - I am trying to identify the hardware to replace broken cranks/operators. The photos show Truth and 40942 (left side window) and 40941 (right side window). I have additional photos and videos if it helps. I need 4 left and 4 right. THank you.

45x39 double awning window

Please let me know what part number I need to order from Swisco to replace this casement hardware, will probably need to order right and left operating systems, with new crank handles as well .

do you sell entry gard truth 20755 left & right

What model is this window hand cranker and do you have it in stock? I need both left and right. Thank you

operating hardware # stamp is 20755. are you able to assist identifying replacement operators? Thank you, Dave Gaal

The window is Milguard from about 1995. The top of the long arm is stamped with "Entry Gard TRUTH" The bottom of the long arm is stamped "30757LH" The shorter angled arm is stamped "30851" The shorter straight arm (attached to the angled arm) is stamped "20312" It looks like the spiral gear on the ... (cont.)

Request assistance with identifying the correct casement window closure hardware in the photos.

I need replace for above referenced crank. Do you have the correct part? Thanks for your help. C.Akkad