Viewing all customer Discussions for:

39-217 Single Arm Window Crank

I am looking for a replacement mechanism for this window. I found the oen for the other larger windows but can't find this one.

The spindle shaft of the crank mechanism of our Uniframe garden window has failed and will not re-engage. Company(Great Lakes Window) no longer carries the part. Recommended contacting Swisco for replacement. No parts stickers on window unit. Only part numbers located were Truth (hardware?) 40575 ... (cont.)

I'm not sure if this will work, these are Anderson windows, we want to replace with the flat folding cranks.

Hello I am looking to find the operator for this casement hardware.Thank you Chris

I need to replace some encasement window crank linkage that has rusted or broke. I also need some bottom seals. Hopefully the pictures will assist with finding the right replacement parts. Can you please advise? I have more photos available if needed.Thank you,Bill

I need one

Hello There,I would like to replace both ( Left & right ) of my CARADCO casement window operators 9-1/2" parts. The original parts have been working since 2000 with a single arm model as shown in the picture attached. Could you please advise me if is it possible to install the Caradco double ar ... (cont.)

I'm looking for what part this might be, for hte opposite window. We believe it' a casement window from crestine. We can see 4840074, but not sure what that is and also Truth. Any help would be great. Thank you!

Seeking direct (or equivalent) replacement for this window operator from 1993. (see photo)These are not broken, but the original design has always had excessive free play within the gear train, allowing the windows considerable movement. The end of the (~ten inch) arm can move by almost 2" just du ... (cont.)

The crank screw on my Pozzi window came out. I can open the window but when I close it, the screw comes out. Can I tighten it somehow, or do I need a new crank? The windows are 16 years old. Thank you Chris

Stamped on the assembly is "Truth" / Pat no. 4,840,075/ Made in USA. Also on one cogwheel is the number 3136 although I am not sure of the last digit. The house was built in 1996. Thank you for your help

I have Crestline Casement windows and need 2 right hand and 2 left hand operators. - They are all of the single arm variety. - The total single arm length is about 9 inches. - The body (where the gears are located) is about 5 inches long. - The operator looks identical to your 39-216 and 39-217. ... (cont.)

Hello, I think I made a mistake in ordering a replacement part. The one I received is not the same as the one in the picture above. Can someone please help me order the correct replacement assembly>

I am looking for a SEMCO casement window operator with the number 31538, it has a "Rivet to Rivet" length of 8 1/4" for a 17" wide window.

I have a Jeld Wen casement window that has an inoperable crank. The crank freely spins . The gears do not connect. The crank mechanism has a stamp reading Pat # 48040.075. That is the only ID information I can find when I removed the sash. Would someone please call me Thank you, Daryl ... (cont.)

My small window operator unfortunately has broken. It's small with only one arm attached to the railing

It is stamped as Truth 45275. The arm is stamped with 40267. Total arm length about 9.5" 4.5" from the end to the bend in the arm. Thank you!

Part is about 30 years old. Has Truth label but no part number.

Need casement operator and related parts, white handle/cover, guides. Pat. No 4,840,075. Made in USA

There are no markings but the part is on the bottom of the window pane as shown in pictures. The windows were Marvin windows probably manufactured early 80s. Marvin.com said they discontinued that part and advised me to check with you guys.