Viewing all customer Discussions for:

70-128 Screen Panel Pull, White

I am looking for this particular screen corner. I had one break on this very thick type of frame. It's a very thin pong that goes into the frame. I'm hoping you can help me out with that. Thank you.

Looking for replacement. This tab seems to go in the bottom of screen channel, not the spline channel

Do I need to insert this pull into the screen before I put in the spline. If so.... what can I do to put pulls into the screen without having to start all over?Suggestions are welcome.Thank you so much,Penny

Hello does your white screen tabs work for Reliabilt window screens Screen Panel Pull, White Product Code: 70-128

Look for balancer rods that go in track on side of window. Picture shows rods that have fallen from windows. They are spring and string assemblys. Need left and right sides.

HI, i purchased size 95-186 but they are a little too large. (Screenshots attached) is there something a little smaller i can try so i can fix my broken screen tabs when i rescreen? the worn looking ones in the pictures are the current ones and the newer ones are the 95-186 size. for comparison. ... (cont.)

I believe these should come in a set of two. A right and left side.

Screen clip and spring latch ?

I'm looking for a more durable pull tab. The plastic ones in the photo function well but became brittle and broke after 3 years. The slot depth of the screen is 3/16". I tried Swisco 70-004 but they pulled out of the screen. Does your nylon part 70-128 last longer than plastic?

Looking for a screen cut corner that matches the Screen Corner Latch with Pull, 7/8" x 5/16"product code 95-218. Tried product code 95-031 but that did not work.

I am having trouble matching my old parts to anything in your catalog, hopefully someone there can help find me the correct replacement corners, thank you

While repairing the screens in my Certaineed windows several of the screen panel pulls broke, I was able to find them on your site 70-128. While cleaning out the frames I cracked several of the clips/keepers that secure the screens to the frames. Do you carry these and what are they correctly cal ... (cont.)

I'm looking to replace many of my worn out window screen corners. The corners I need are at the bottom of the screens only. I need some sort of pull ring to extract the screen from the window using my fingers. The screen frame is 1/4". The corner of the part in question measures approx 3/4" from the ... (cont.)

There are no markings on theses corners. They are from screens on Silverline single hung windows circa 2002-2005. Note the exposed corner dimensions of 7/8" . The frame is 5/16" x 3/4". Would also like to have corners with lifts as well. I think they may have been out of production. ... (cont.)

Hi. I'm looking to replace a number of screen tabs. As you can tell from the photo the tab broke of and the rest of the table is still inside the spline. Do you have a product that could replace what I have and please provide the cost to include shipping.If you have no replacement product to accommo ... (cont.)

I sent you an email yesterday with questions about window parts. As I found out the pull tabs on my screens are brittle and break off when I try to remove the screen. It looks like item 95-186 will replace the ones I have. My question is how to get the old corner out without destroying the screen ... (cont.)

Do you carry a corner like the 95-186 and 95-187 that would better fit a .170 spline. Thanks, Joe

I need to replace these plastic corner pieces for the screen frames. I need 24 of them. They are all dried out and broken.

Can you provide installation instructions?

I am trying to find replacement pull tabs to fit a screen on a Milgard window. I would greatly prefer to find one that is a loop, like the original rather than the solid tabs that I seem to be finding. Any ideas on how to find some that will fit?