Viewing all customer Discussions for:

81-223 1-1/8"dia Replacement Steel Concave BB Wheel

Looking to find out who makes this and if I can buy replacement roller bearings. The roller has seized aft 30+ years. Side of the assembly has either 891 or 198 etched. Wheel is OD is 1 1/8 I measured multiple time to ensure it was no one inch or one and a quarter

I am looking for such wheels

I am not able to find a 1 inch roller glide

Hi There, I can't find these patio door wheels and I was hoping you'd have a recommendation for an alternative that might have the same function/size. There is an inner housing that slides down to adjust the wheel 2 1/8" Long 1 1/4" High 5/8" Thick 3/4" Thick at the end with the lip 1" Wheel Diam ... (cont.)

I've searched for hours online and can only find steel versus stainless steel with the dimensions of my roller assy. My house is at the coast and steel will not last long. It's the same size as your product code 81-181 which has rollers to large and will not fit in my door. An help you can provide ... (cont.)

Patio door rollers - I need a pair! These are 1-1/8 inch high by 11/16 wide, with 1-1/8" tandem wheels

Need 2 replacement rollers please see photos

Saar

Hello, I don't see any markings are numbers on the door itself but this is the wheel that I took off

No marking on wheels or doors

About 23 years old. No names or numbers.

Do you have patio door rollers to match these or a replacement roller. The rollers are 1 1/8" Steel Ball Bearing Rollers. Any help would be greatly appreciated

Which track is compatible with the 23-092 roller? The center measurement between the two rails on my current track is 1 5/8". I purchased a track from Lowes and the guard rails on each side were too high and the roller wheel could not reach the rail.

I have an aluminum sliding door in our basement. I believe it might be original with the house ~1969. The nylon rollers are shot, and I'm trying to replace them. I got the door out, only to find that I believe the roller assemblies are riveted to the bottom stile of the door. I marked the rivet ... (cont.)

Greetings, I need to replace the rollers on my patio door. The dimensions are:2 1/2" x 5/16", the wheel is 15/16". Please help image.jpg Rob

my current roller has the same measurements as 23-092, with a nylon wheel. My measure, wheel diameter 1/8, 3/4 flare, with 9/16 inches.The 23-043 diameter is 1/8 longer than my roller. Should I buy 23-092 or 23-043?For tha matching track 23-271.My door frame opening is 59.5 inch. Will 0.5 shorter th ... (cont.)

I am wondering if you have the replacement wheels for the sliding doors for this sumroom? Thank You Derek

ball bearing wheel from sliding door on boat built in taiwan in 1987. out side diameter 1.25 inch. width 5/16. The axel appear to be stepped - 1/4 in diameter to 3/16 diameter. Or the axel is maybe a 1/4 inch with a 3/16 inch pin or rivet. The wheel is mounted to a 1mm thick stainless steel carrie ... (cont.)

i need parts Patio Glass Door Single Wheel Rollers the size is for an over 25 year old door its 1 inch high 2 9/16 long and 1/2 inch wide

My vinyl sliding glass door needs a new roller. The assembly I removed from my door looks like your product code 81-158 except that it has 1" diameter rollers. All the other dimensions are identical: 3" long, 1" high, 11/16" wide. There are no numbers or markings on my assembly that I could find. Do ... (cont.)