Viewing all customer Discussions for:

82-005 Surface Mount Sliding Door Handle Assembly, 4-15/16"

Hi, I am looking for a lock with key to install on my sliding glass patio door. I have a handle but would not mind getting another handle that the lock would fit in. I actually wanted a keyless lock but cannot find you that I think would work. Thanks, Carol My glass door is about 1" thick. With ... (cont.)

Help!

Locking mechanism does not catch with door latch. Hook part is Kind of wobbly. Actually, hook is coming up in wrong Direction

Early 1970s era very tall aluminum slider -- looks like commercial storefront; Lock control knob broken, inner lock mechanism fell inside door. Would like to refurbish or replace sliding door handle and broken inside lock control knob and missing internal lock sliding mechanism. Have two other matc ... (cont.)

The handles are 12 inches long and the attachment holes are 10 inches apart. Also need to back side of the handles as well

I need a new door handle and lock

Hi there, Do you know if I can still buy the piece that screws on? It's the little lock ... as you May be able to see in the one pic... Part of the piece that comes up and grabs the hole in the frame broke off And now we can't lock it.

The interior handle mounting screws are just under 5 inches apart and this is a surface mount lock. The objective is to make the exterior a keyed entry.

Hello, I am looking to replace the handles, latch & strike plate on these sliding & screen doors. Do you have any advice? Thank you.

Hi there! I'm in desperate need of a replacement keyed handle. This was surface mounted. There's no latch hole in the door. The measurements are proving to be VERY difficult to find a replacement handle. Thanks in advance for the help!!

The lock broke o the sliding glass door. Need to replace the handle. I've purchased two different handles from local hardware stores and neither fit.Looking for the correct replacement part. The screws do seem to be 3 15/16" on center.

I'm looking for a keyed handle set for a sliding glass patio door. I'm attaching some photos of the handle I'd like to replace, and was hoping you could help me identify the correct size. I removed the handle and here's what I measured. The mounting holes are actually 3-1/2". The lock lever is ... (cont.)

I am looking for a universal replacement for this patio door. The mounting screws are only 3" apart and I understand I will have to drill new holes. I'm not sure which mortise latch would be best on this door. Removing the handle will destroy it because screws are frozen and heads are stripped. ... (cont.)

Hi all - I''m sure this handle is no longer in production but I can't find one in the usual places (Menards, Home Depot, etc.) that will work as an alternative. Any suggestions would be greatly appreciated! I tried to upload photos but the site didn't seem to work - is there an email address I can s ... (cont.)

This is the only picture I have of this door handle

I require a uPVC sliding patio door handle 204mm screw hole centres. Or 8 Imperial inches. It is an old size hard to obtain. Preferably it needs to be sturdy against breakages. Unlike what is presently fitted which is tearing I have had it Tig welded recently

Hi, I am trying to find a replacement part. I have a door that has the same hardware but the slide lock lever broke. Thanks, Amanda

Hello, Looking for two each, glass sliding door handles. One keyed and the other not keyed/picture attached. The handle snaps after a few thousand uses (fatigue) which you can see in the photo, I installed supports to keep the handle working over the years. 4-15/16" o.c for handle this handle de ... (cont.)

The holes are 5 1/8" center to center. The door is 1 1/2" thick

Good afternoon:I am looking for replacement sliding glass door handles/locks for two (2) DARYL Manufacturing sliding glass doors. One of the handles/locks has the numbers 15047 & 15049 etched on it. The other handle/lock has the numbers 15048 & 15050 etched on it. The actual handle pulls ... (cont.)