Viewing all customer Discussions for:

82-005 Surface Mount Sliding Door Handle Assembly, 4-15/16"

We are needing to replace the handle on this old sliding glass door. We are purchasing this house and need a way to lock it. We have searched all over the door and the handle for any form of manufacturer numbers and we are unable to find any. The pictures are of the front and the side view of the ha ... (cont.)

i believe this is missing a molding astragal for the clamp to bite onto and close the gap. I would ideally replace this handle with a keyed entry locking one instead. Doesn't look like they are manufactured anymore but maybe someone has one in stock. any advice would be greatly appreciated ... (cont.)

Sliding window door lock for Arcadia window from the 1950's.

Need to find replacement lock/handle set for Citation Model 80 sliding door. Installed in 2007.

nw1720-1 Taiwan nw1720-2 Taiwan nw1720-3 Taiwan

I want to change the pictured to your Product Code: 82-081. Will it fit or what do I need to measure? Any help will be greatly appreciated.

Hi there, We are looking for a replacement handle for our Arcadia Series 600 sliding glass door (MSA 5'1"x 6'9" Code: NS-1 and SGD-A1). I run a historic house museum and would like to avoid replacing the door altogether. Thanks in advance for any help!

i am looking for lock , Please let me know where can i buy it, it is guardian model , top and bottom holes space 5 inches

Please let me know if you have this handle with latch. Note the direction of the latch , it is facing inwards. Thank you for your help. RT

I purchased a home that had 2 sliding doors side by side. One slid open to the right, the other to the left. I need a replacement handle now for both. Please notify me when or if this product is available for purchase. Thank you in advance.

Hi I am trying to find 4 replacement handle sets for my sliding doors. They are really old. In the picture you will see it says pd below the lever latch. The screws are 7 inches apart installation screw centers. Also there is an additional screw right above the lever. Similar to 82-223 The handle ... (cont.)

Did the 82-005 work for the Lanaidor patio door?

I have attached 2 photos....The part i received is too small and looks off. The screw holes on my part in the door are 3.75 inches apart. Could you please let me know what the next steps might be. Thanks, Chris

Hi ,Please let me knw if you may carry this replacement part... it is from an old 1960's door model with no brand or markings of any kind... or if may have any suggestions as to where I could be looking for it...Thanks so much for your help,Sincerely,Orlando

Attempting to locate the attached handles for a Levittown, PA Levittown home. They appear to be made by PARLYN, model on the handle is 999R. The primary screws are 3 1/2 inches apart.. the length was of handle is approximately 5 inches.

I'm looking for a replacement handle with the lock latch in the middle. I thought this was an Andersen door but Andersen says they have never had a lock as part of the handle. There is no outside key to unlock the door. The pictures include a makeshift handle. Thank you, Steve

Looking for sliding patio door handles with 5 1/2 center to center with intererior lock if possible

Hi guys, approx 1988 vintage sliding pateo door latch broken. Held in with plastic clip. Says "Reflectolite Products", Sun Valley CA. Looking for replacement parts. Thanks Karl Tacoma WA

I've looked all over for replacement handle to no avail. Top part of Handle split vertical (duct tape covering in photo so handle is useable to get outside). Center-to-center hole of screws is 5 5/8" and 6" from bottom of bottom screw to top of top screw. Total height is 7 1/2" I have no idea whom o ... (cont.)

Looking for a replacement latch for the handle