Viewing all customer Discussions for:

82-005 Surface Mount Sliding Door Handle Assembly, 4-15/16"

Did the 82-005 work for the Lanaidor patio door?

I have attached 2 photos....The part i received is too small and looks off. The screw holes on my part in the door are 3.75 inches apart. Could you please let me know what the next steps might be. Thanks, Chris

Hi ,Please let me knw if you may carry this replacement part... it is from an old 1960's door model with no brand or markings of any kind... or if may have any suggestions as to where I could be looking for it...Thanks so much for your help,Sincerely,Orlando

Attempting to locate the attached handles for a Levittown, PA Levittown home. They appear to be made by PARLYN, model on the handle is 999R. The primary screws are 3 1/2 inches apart.. the length was of handle is approximately 5 inches.

I'm looking for a replacement handle with the lock latch in the middle. I thought this was an Andersen door but Andersen says they have never had a lock as part of the handle. There is no outside key to unlock the door. The pictures include a makeshift handle. Thank you, Steve

Looking for sliding patio door handles with 5 1/2 center to center with intererior lock if possible

Hi guys, approx 1988 vintage sliding pateo door latch broken. Held in with plastic clip. Says "Reflectolite Products", Sun Valley CA. Looking for replacement parts. Thanks Karl Tacoma WA

I've looked all over for replacement handle to no avail. Top part of Handle split vertical (duct tape covering in photo so handle is useable to get outside). Center-to-center hole of screws is 5 5/8" and 6" from bottom of bottom screw to top of top screw. Total height is 7 1/2" I have no idea whom o ... (cont.)

Looking for a replacement latch for the handle

Hello, I am looking for options to replace my sliding door handles. The screws are oddly sized at 3 and 3/4 inches. Can you help? Sincerely Matt

Where can I find this part for my sliding glass door

Need a new patio door handle..There are only three holes. The mounting holes are about 6 1/2 or 6 5/8 inches apart. The third hole is offset and closer to the bottom. The diameter is 3/4 in. And it is 2 1/2 in away from the bottom mounting hole (center to center). The entire handle was 7 1/2. It ... (cont.)

Thanks for writing in. We don't have an exact match for this handle set, but we do have a possible substitute. See our 82-005 Surface Mount Handle Set. You will likely need to drill new holes to attach it to your door. Take a look and see what you think.

Screws appear to be 4 3/4 inch apart, center to center. Door is 1 inch thick. Locking mechanism is loose and will not stay in one place.

Hi do you happen to have a replacement for the broken lucite handle?

We've had the sliding glass door since 1960. The Lucite handle broke. Can we get replacement handle or lucite insert?

I am on the hunt for a new handle for this Peachtree sliding door. The one tricky part is that the homeowner wants the have a keyed lock on this door, verses the lever lock currently installed. What are my options out there for keyed, lockable handles to bolt on replace the existing handle with mini ... (cont.)

Hi, what kind of locking mechanism/part do I need to add to my door handle to make it a keyed entry sliding door? Where can I find it ? I think the link below shows the same lock as mine. 82-005Will appreciate your help.Thanks,Yasin

Handle has four holes. Two to secure handles & two to contain lock mechanism.

Panaview is the only inscription I can find. It is a large sliding glass door probably from the 70s.