Viewing all customer Discussions for:

82-005 Surface Mount Sliding Door Handle Assembly, 4-15/16"

I have a new set of doors and I need some door handles and a lock for it. I have another set of doors with a current set of handles and would like to match as close to this as possible. What does Swisco have that can match this 4 15/16 hole pattern external locking handle?

I'm looking for a replacement handle and latch for an older sliding glass door. The door is only 1" thick The existing holes are 3 15/16" apart. Would like to find something in a darker finish. Any help is greatly appreciated.

My house was built in the 1950s with a large patio door in the family room. I have the same door handle configuration on the inside and outside of the door. The photo is of the inside door pull. On the outside, the plexiglass cylinder is missing. So I'm looking to replace the outside pull with one t ... (cont.)

In an older home in San Diego California. Tooth on lock mechanism broken on each of three doors. Sliding glass Doors work well new wheel bearings installed. Just need to see if parts available to repair latching/lock mechanism

Do you have parts? The plastic thumb latch (red arrow in pic) on some is broken. I can activate the mechanism with a flat screwdriver through the round hole in the side. Looking for replacement Arcadia parts OR entire handle/lock that would be a suitable replacement. Last resort: A separate lock/lat ... (cont.)

1980s sliding screen door. Have no clue where to find the correct latching system.

I'm trying to buy replacement patio door handles for my wooden sliding doors. the building was built in 2002, but I don't know where to find these handles. What I see: This is a surface-mount pull handle for a wood sliding patio door. The handle is silver/grey plastic, two-piece, with two through b ... (cont.)

I want to replace a broken door handle on my sliding door. I have photos to explain my existing door handle. I believe the mechanism is what you call "surface mounted." Mounting screws are 2 and 3/4 inches apart.

sliding door handle replacement

Need to find a replacement of this handle with the latch.

Hi! I have an old door handle and latch lock that needs to be replaced. Below are pictures. It has two 3-inch centered holes and there is a hinge mechanism on top of the handle that slides over a latch which is attached to the outer edge of the steel door frame. The house was built in 1950. The new ... (cont.)

Need to find a replacement for the outside handle (The one in picture that has no wood)

Hi, Your company always bails me out when I need parts, so here I go again. I require a replacement, locking, handle set for a sliding glass door. Easy so far, however , the screwset to attach has an offset of 5-1/2" (MAYBE 5-9/16) please see attached. I can't find ANYTHING, ANYWHERE with this size. ... (cont.)

Hello, my old Arcadia plastic handle on the motor lock is broke. I understand they don't make days anymore? The handle set has 3 15/16 inch holes and on the attached picture it says US PAT 2,701,157 2,701,157 any help finding a replacement would be greatly appreciated!

It is about 35 years old

Latch does not close/snap into place properly anymore

Hi -- my latch flops around. Looks like you sell the replacement door lock. However, I don't know how to disassemble the door handle to remove/replace the lock, so I'd like to know if you might sell the entire assembly. Then I can simply screw it on. Thank you! --Jon

Hi, I'm trying to determine a suitable replacement for the handle in the attached pictures. It's quite old and seems that there are no similar repalcements avaialbel anymore. I've noticed the 82-261C and the 82-005 as possible replacements. Any other possibilities? Any help would be much appreciated ... (cont.)

From a house built in the mid 50's in Oregon. If just the lever is available, that's all that is needed.

I cannot find a replacement striker for this 80's style sliding door.