Viewing all customer Discussions for:

82-218 Mortise Lock, Round Face, 3-11/16"

I think I need this 82-227 Mortise Lock to replace mine. On mine the latch won't pop out anymore when the lock is turned open. Can you confirm this will fix that? Thanks. See pic.

Hi, I have a viking sliding door series 8500. My Mortise lock is broken and wanted to replace it or order new assembly. Would you have it available? Thanks, Anuj

I need this mortise lock

I have a sliding glass door that I am looking for the locking mechanism. The only part # I can read is Series 850 CCMC #12747-L Do you have this replacement part? Thank you!Steven

Gorell sliding patio door #6003 Looking for new lock Al

Dear customer Service Representative, I apologize, the package with the screws, tube nuts, and keys had dropped when I opened the package. However, I do have a delemma , the mortise is slightly larger than my opening, do you have any suggestion? Did I order the wrong part?

Need all of the parts

Hi: I attached a picture of the lock I need. I don

I am looking to replace a sliding glass door handle set. I have sent you an image The distance between the screws looks like 4 inches but not sure if it is measured center to center or end to end, since many handles seem to be 3 15/16 perhaps that is the size. The unit is about 25 years old, i ... (cont.)

I bought a replacement 82-218 (Mortise lock) and 82-106 (turning lever), but the turning lever is not long enough to reach into the mortise lock mechanism. Does your company sell a turning lever with a longer shaft?

Need sliding door part

I have a rental and I am looking for the inner locking part. Unfortunately, the last tenant took out the original so I do not have an actual sample of the part. The measurements that I have are 3 and 11/16 for the length (middle of the screw hole to the middle of the other screw hole). 3/4 of an in ... (cont.)

I'm looking to replace the lock below....... The letters DNS are stamped on it and it is from a Weathershield sliding glass exterior door from around 1996. Do you have such a part? If not, do you know where I can find one? Thanks Larry C.

I need replacement door handles and the hardware for them. The door is an American Craftsmen Gliding Patio Door (5500/5700 Patio Door).

Sirs: I have identified the lock which will replace the barely functioning lock in my patio door. It is the 82-218 with the "rounded" corners. The dimensions on your webpage graphics match up "on the money" [CTC screws/lockface/etc]. Sidebar: I understand the problem is an oval-shaped rod/pin ... (cont.)

Hello, I need to replace the mortise lock in my sliding glass door (spring broke). Dou have this style (2320-1061)? Thanks, Jared

Can you supply mortise lock for 1989 Eagle sliding door like your part #82-226 except measurements between screws is 3-9/16" and overall is 4-1/2"? Can you help?

The pictures of the door should be attached to this email for you to forward. Travis

looking for a replacement assembly inside and out with the mech.Dont have any written info on door,jamb or hardware

I bought the home in 2008 and the builder is D R Horton. I could not locate any info on the door. I have attached pics.