Viewing all customer Discussions for:

17-037 RH Cam Pivot, 9/16"

This part has one screw into window sash and the pin gets set into the spring assist

I have channel balances in my aluminum window. The shoe is destroyed. How do I get it out to identify it? And even more important how do I get the new one in?

Lauren, I am resending the pictures. I will send 4 first. Then 3. Please let me know if you get them. Thank you. Daryl

Needed this one

This part connects to a spring mechanism that that assists window to go up and down. Thank you. Jim

I am trying to find out what this part is.

These are channel balances I need to replace. They are stamped 27-10 (therefore 28" long) but have a pivot shoe I have never seen before. The channel it fits in appx. 1" wide. The piece on the sash is a (half round??) piece of plastic, again something I have never seen before. There is a rectangular ... (cont.)

Hello, I am looking for this window part for our Resort Windows. Would please help me. Thank you, Leydi

What I have very much resembles the dimensions shown in the catalog photos of 17-036 and 17-037. While I am on a roll asking a variety of other questions regarding my aging windows and unwillingness to replace them at this juncture: The overall length of my pivot cam pivot is a touch longer, about ... (cont.)

I looked on the website but I couldn't find a match.

I need the corner pivot pins/bars and sliders with the springs inside. I think the bottom is broken. The bottom of the channel bar with the hook is missing the attachment that the cam pin goes into. If you want to call me. What about the 20 channel bars? Here is a picture. I need 6 of the channel ... (cont.)

Hi, Dimensions are 1 5/16 from the tip of the T-Bar where it enters the shoe to where it is screwed in to the window. Img 4941 IMG 4940 is 1 inch in length and 5/8 wide. Need qty 2 of these. Frank

I am trying to find a sash pivot for an aluminum double dung window. I don't know the manufacturer. Overall length is 1-1/8" width is 9/16" post has slight taper so these are handed left or right. Pivot portion is 1/2" x 3/16" on one side down to 1/8" on other side. What do you think? Fred Amabile ... (cont.)

I need 2 of the legs that screw into the sash. These ultimately fit into the u-shaped balance shoes in the casing. The attached pictures show the 'good' part. On another window, the leg portion has broken off, so there is nothing to lock into the balance shoes.

Can you recommend a substitution for this or help me find the match? Have no idea the make of window but they are about 40 years old I think installed or sold by Sears. Also would need pivot shoes to work with them. 10 in quantity each piece. Thanks in advance for you time. Connie ... (cont.)

This part appears to be cast aluminumm (broken in two pieces), and it's attached via screws to the bottom/lower slash. It goes on the bottom of the sash, and the slot fits into a sliding bracket that is inside the window frame. Thanks!

Looking for die cast pivot bar for bottom window sash. Can you help me identify for replacement(s)? Do not know if pivot bar can be used on either side. Curious as to how such bar is attached to the window sash. Thanks for you help and advice.

Please tell me if you have this part!!!

Pivot bar for a Pacesetter window. 11/4" from end of pivot bar to end of small piece that slides into window. Pivot bar is 3/16ths long looking at it from the end. Slightly wider at top versus the bottom. Holes are 3/16ths and 1/2" from under side of bar.