Viewing all customer Discussions for:

S351-27 27" Series 351 Channel Balance

I have older windows built earlier than 1940s and I would like to know if I should get the 351 series or the 390 series. There is marking 2620. Please advise. Thank you.

Dear Sirs &/or Madams: Attached are several photos of Window balances and removal clips from "Crown single hung, 2 sashed windows that I purchased back in 1999?. The window sash weighs 18 pounds, and the balance is 27", measuring the metal only top to bottom. The banance is 1/2 thick. It appe ... (cont.)

need 2 of each: 25 5 FX CMC metal part is 26in long 36 4 FX CMC 11 metal part is 37in long Do you have replacment and what is the part number, can i get them before 9/27 Thank You

It is 27". Marking is 26 4 EX CMC 7. I will need 2 of them. Thanks

I am trying to find the correct replacement.

Need to replace both Sash balances for non tilting window sash. I need the right part. Thanks

Hi.... Metal is 27 inches 28 with the ends... 1/2 inch wide. Has hook on the end.

27" metal channel 1/2" width block and tackle no part no. need replacement for lower double hung window 27"x 30"

Appears to be 1/2" thick. metal to metal 27" long. Total letting 28"

I don't know what series it is? I just know it is 27"

Hi, I'm looking to replace four balance pieces. They measure 27" from the metal and have the marking of 2640, BSI, and VT. I included pictures that hopefully show enough to see the distance of the holes where the balance installs into. Let me know any other info you need. Thank you! ... (cont.)

Hi, I need 12 qty above window slider

The channel balance is roughly 27 inches without the end caps. Has 26 2 ft cmc 2 stamped on it. Roughly 5/8 wide

Can you please help me with correct balancer.

27" is the length of the metal Chanel. It is stamped with 2630. If you need better photos I'll have to remove it again for more info. Thanks

Hi, I need to change the channel balances on two windows (see attached photos). I have narrowed it down to models 351 and 390, but I can't tell the difference between the two. The length is 27 inches. The current balances are labeled 2630 and 2620 (right and left side). Can you help me understand wh ... (cont.)

We are looking to get 4 replacement rails that match the spec in the photos above. Measurements of the metal rail = 27", W = 1/2"Thanks, Brian

Looking for these window balances, marked 26-5 BA CMC 11. Will be ordering 10 of them.

I need to replace window balances on my 80's aluminum, single hung windows. I pulled the broken one out, which is also missing the shoes, and measured it. The metal is 27" long and it's 1/2" wide. It has 26 c engraved on it. Any help figuring out which balance and shoes I need would be very helpful. ... (cont.)

And need 2 window mounts with two screws. the part is 2 1/4" long