Viewing all customer Discussions for:

S390-31 31" Series 390 Channel Balance

If you look at the 1st pic : 96 (I think it's a six, but it's kind of faded), 30-3 HC5 CMC

Two Vertical Windows need channel balances (Total of 4) 32" (3020) 5/8" (see pictures)

Trying to figure out what part this is

I have the same 3030 stamping on my channel balance. I need to replace four of them. Was curious if the issue was resolved and how can I order them?

Single hung vinyl window. Part stamp is 3030 BSL It appears to be a 1/2 inch channel. What would the spring # be? It appears to one of your first listed channel spring shown on your page.

Hello, I need replacement block & tackle window balances. Mine are labelled " 30 5 JQ CALDWELL" on the back.

Hi, My window balance broke, I need a new one. Can you please help to identify this and quote a replacement if possible? I'd love to get one ordered immediately.

Hello! Can't identify this part. There is only one littering "3030"

I have a 31" channel balance that I need to replace. I believe that it would be one of your Series 390 balances (S390-31). It has a 1 1/8" width bottom shoe. The only marking on it is 3016, I don't know which 30XX to order. The window measures 34 1/4" wide by 32 1/2" high. It weighs 25 pounds. ... (cont.)

I like to find the spots to order.

I need to replace the complete assembly in 3 windows, so 6 of each Channel/guides/balance. The windows are approximately 24 years and the assemblies might have been replaced by a handy person in the past so I am not sure the pictures are the original hardware or the replacements. Could you please ... (cont.)

I have a broken balance that I'd like to replace. It's 1/2" wide and 31" long. It has "30-4 AP5 CMC 43" printed on the metal in blue ink. I think it's the Series 351. The bottom shoe looks like it's 1 1/8" deep.

30 A is stamped on the ballast

This balance is imprinted 30 C 3.S.I. The metal case seems to be 31" long. It has string and spring inside with plastic clips on the ends. I'll looking to purchase 20 of these. Please help. Thanks

Old aluminum up and down slider window 3010 stamp on it 1/2 in 31 in long

Hello. I have 25 yr old windows that were installed during new construction in 1998. The window manufacturer was out of Canada. Right now I need 6x 25in and 6x 31in. I will order more later. Ple see attached pics. Ple provide part #s so I can place order. Thank you: Zolie. Plymouth, MI. ... (cont.)

Here's what I got: -- Metal part is 30 & 1/2" in length -- Non-tilt window -- Balance width is 1/2" -- Slider top fitting has plastic tab that hooks onto frame metal tab which to grabs and hold "balance slider" in the frame track when metal frame tab is open. Does not grab balance slider ... (cont.)

31 inch metal 1and 1/16 on the plastic part

Hello. I hope you can help with this I believe this is from the series 395 Chanel balance. The number stamp in the balance is 3020. Also will need that top guide the part that goes attached to the window sash to retain the balance.

Need replacement balances