Viewing all customer Discussions for:

21-161 5/16" E-Ring

How does the arm of the crank attach to the hole in the arm of the window? Is it a threaded bushing with a screw?

Hi, I do not know what the part is called but it is a half-moon pin joining the arm that opens when cranked. I am looking for that pin/moon part. Thank you

HiNeed to replace the lost pin for the closet door For my mother in Florida as soon as possibleI need this in a rush Thank you very much

I ordered the 39-026 and it was very close but I need a different end. to attach to the window. Hopefully you can find it I attached several photos of the one I need.

I can't identify the brand of jalousie windows. I need the rivets, rivet casing/washer and clips for (a) connecting elbow parts together and (b) connecting the parts to the side wall track. (ie. I've already purchased a couple of new crank boxes, but the rivets I bought to connect them to the re ... (cont.)

I need about 6 of these guide pins so I want to make sure I get it right. Can you help identify the correct pin? As you can see from one of the photos, the current pins (or the broken pins) were 4 1/2 inches long. These are metal doors, fairly old in my estimation. I'm sorry that some of the photos ... (cont.)

Looking for these parts for old crank swing windows

Trying to figure out what replacement part I should get for this awning operator? And how to install...in your video it looks like there should be a screw to remove but it does not look like a screw?

I need the adjusting pin (shown in picture) And the spring and plastic retaining clip (pencil pointing to missing retaining clip) in the second picture.

Can you please advise the part number to the window crank in the attached photo, along with a link to it? The crank is stripped and will not close the window. Ed

Trying to locate the cotter pin to reconnect crank to window.

I ordered the 39-025 but I'm unable to remove the quarter inch size sticking out of the arm. Please see picture.

No manufacturers identification on handle. 5/14" center of top hole to center of bottom.

Hello, I recently bought a 39-074 : Lenahan Window Crank. How does the arm of the crank fasten to the awning. I bought 33-067 and 33-207 but I don't know how they go together or what the threads on the 3/8 shoulder screw screw into. The arm on my awning just has a hole. The same as the hole in ... (cont.)

The torque arm measurements are: 52 1/2" long , and the arms on each end are approximately 3 1/4" & 4 1/4" from the centerline of the torque shaft to the center of each of the 2 pins on the arm. The two pins are both approximately .310 " in diameter, with a C clip groove . The arms are offset, wit ... (cont.)

is this part available?

Need this for my jealousy window

Attached are pics of the parts.They are from a metal bifold closet door.

pin is steel i/4" diameter, 4 1/2" long including nylon slider cap. Pin has two grooves 1/2" apart around the middle encircling pin is a spring 1 3/4" long, 5/8" in diameter for 1" narrowing to 3/8" at the othe end the spring floats free on the pin in the door channel through which the pi ... (cont.)

I need to identify, and then order a pin for a Fenestra bi-fold closet door. While in place, it measure 4.25 inches in length. I, unfortunately, do not have a picture of the pin uninstalled. If it helps, the door itself is 93.5 inches long. Thank you, Kevin