Viewing all customer Discussions for:

39-286 Casement Window Handle, fits Andersen

Childcare building was built in 1999 by an architect who had no clue what kids would do to hand crank windows. Of the 32 windows in the building, only 2 handles survived (in the director's office). I need to identify these parts, buy and install.

Need replacement left window casement operator

casement window operator - dual-arm operator.I don't have the measurements.

I need the whole operator. The existing one opens the window but can not close it; it pops out.

I need to replace the entire mechanism that cranks open the window. The plate cover on the crank is labeled Anderson. The round crank shaft is stripped and the handle can't get a tight grip on the shaft, even with set screw fully tightened. I am not sure what year these were installed. The case cove ... (cont.)

On the window operator it says, "99 /04-3a" and on one of the arms "39"

The handle doesn't grip anymore

Need a right & left Anderson Windowalls crank arm & slide. 9 inches long. Markings on hardware- "Anderson Windowalls, Bayport, Minn., 55003, 79, L". On backside markings- "NO 19 7198-17"

Hello i have a Anderson casement window . It will work going out but not in. The plastic plate is cracked. Do I need to replace just the plate to make it work or the whole thing? Also do you have the replacement part? Thank you Jared

Hi, there is nothing to identify the window that is legible that this crank is attached to. After the window was open the crank did nothing to help close it. The wind shut the window. Can you help me, I'll find out any other additional information you need from me to help you. Thanks in advance ... (cont.)

Good day, can you help me verify the item? I have an old andersen crank, I think it's a 39-150 (or 39-094) part. have stamp in the arm 118 s i send a picture

I'm "handy enough" to make the repairs once I have parts in hand. Help!!

Looking for new hardware. Thank you.

I need an replacement operator kit for my Anderson awning window. I ordered the wrong part which was part # 39-839

Need crank mechanism replacement for Anderson casement window. Window opens out to the right.

I am looking for the spot replacement. I have three window. I am not sure because I am looking at the website and it doesn't match anywhere if you could help me it's much appreciated. Thank you

There is a number on the arm itself at the end 108. on the bottom of the crank assembly mounting is a number 71912 as shown in the picture

Hello craige again. Please identify the crank. I am in need of 2 of them for both windows

Need left and right. Anderson window

Window crank needs replacing