Viewing all customer Discussions for:

33-073 8-15 x 1/2" Truss Head SS Phillips Screw

I need to replace 1 pivot shoe and a few coil balances. The only marking is a faint imprint of "8" on the coil balances. Thanks for your help.

No markings?

BIu

Looking for a replacement dual coil balance and shoe assembly.

Hello: Hope you can assit me in getting the parts needed for my window. In the Photo the spring is the broken one on the left , spring on the right is good as far as I can see. The item below the broken spring is what I call a T Bar, which is goes on the bottom of the window so you can tilt the wi ... (cont.)

I need replacement coil spring balancers for two windows. I am unable to find any identifying markings, serial numbers, weight ratings, etc. Pictures are uploaded. House is in a development in Southern New Jersey, built new in 2003.

Thanx for your help. Have windows put in over 20 years ago by window world. Have problems w/ these that they say they can't help me with. I cannot see any numbers or manufacturers on these parts. They are: Coil snapped - coil - 1/2" wide - pics 1-3, this is on a bathroom window single hung Pivot ... (cont.)

Can you identify this item? The coil number is 602.

I'm looking to purchase the window parts I have attached. Thank you for your advise. Ron

Look for replacement parts on this single hung tilt out window.

This coil spring has a 9 stamped on it. I need the left and the right side. They both broke.

Trying to find something similar to this one. If you look close it has a 4 on one side and a 5 on the other.. We would definitely buy 2 if we figure out the correct one.

Hi, We have to replace this for around 6 windows and are trying to figure out which of your products we should purchase. Any help is appreciated. Sincerely, CJ

This is a picture of the parts that I removed after the pivot shoe lock broke from the assembly. Can you help me order the replacement parts? There is a numer 5 stamped on the coil spring.Thank you.D. Brown

coil stamped 932 single coil for I believe alside window 4 balance assemblies

I need the part where the window goes in on each sides so the window can slide up and down I need both sides.

This a coil spring for a Certainteed lower inside sash. I need help indentfying your part number

Pin replacement to sliding guide. 1st pic shows pin missing.

Hi, I think I need the 15-177 coil balance shoe, the 15-144 coil bushing cap, the 15-145 coil support barrel and the S152-7 7 lb 152 series coil balance (the current one is stamped 7) and 33-072 Philips screw. 2 of each, but I’m concerned that the shoe may be too wide (the current one measures ... (cont.)

Both window balances are missing, so I do not have a picture of what I need.