Viewing all customer Discussions for:

S385-18 18" Series 385 Channel Balance

I have these channel balance similar to similar to series 380 and 385 but not sure which one to pick. Looks to be 17 inches when measured and 1/2 in.label on back 17 3 DP caldwell

Hi, I would like to know what product matches the "17-5 CMC 2" window balance. Thanks! Best, Sarkis

17 4 BR CALDWELL is what is stamped on part.

I have two caldwell window channel balance I need to replace. One is stamped 17 4 GR Caldwell. The other one is stamped 32 4 HR Caldwell. Both are 1/2" size. Please tell me which one to buy. Thanks Existing channel balances: 17 4 GR Caldwell 32 4 HR Caldwell both are 1/2" wide and 9/16" deep ... (cont.)

I need to order 4 sets of channel balances for 4 windows. The channel balance is 18" by 1/2". Attached are the pictures. Let me know if you need anything else. Thanks, Bob

What part#'s are these 2 lengths?: 1. Stamp 17 3 HT CMC 4 Metal shaft: 18" x 1/2" 2. Stamp 28 4 KS CALDWELL Metal Shaft: 29" x 1/2" Thank you! Kalei

I need a replacement for the above

Hi! Just wanted to make sure I get the correct product before buying these for the whole house. "17 1" and "A 1" engraved on side. Unsure of weight rating. I was overly enthusiastic when removing the window and a plastic piece broke off but not sure if from this channel balance or the other one but ... (cont.)

Hi! I'm looking to replace a few Milgard Caldwell channel balancers. The stamp on the existing ones read: 17 9 26# LO Caldwell. What's the correct series balancer to purchase? Thanks! Ryan

Part number :b A1740

Need to order 2 channel balancers for one window the markings on them (17 4 DS CALDWELL) attached are 10 pictures measuring 18in each. Please let me know which ones I need to order. Thanks James

Measurement is tiny bit less than 18in.

Hi The # that they have is J 17-5 and the measurement is 18 inches long and 1/2 wire

Item needs winged top and bottom plastic piecesSteve

Dear Sir / Madam,I want to buy this Sash Balance for Single Hung Windows, but they must be complete with the correct Rod Ends installed on them.Inscription on the balance: B.S.I. 1710 FD and it's complete measurement is 18.9 Inches long.Please reply at your earliest convenience,Best Regards,Orlando ... (cont.)

shoe is broken and I need a pair

My left channel rod of my window broke. I would like to replace the channel rods. I am including pictures. The Metal Channel is 18" I am including pics so you could see the measurements. Please help me picking what part should I order. Thanks!!!

Hello I need help determining the correct window balances for my window and ordering them. Let me know what other info you require to help me. Thank you.

How would I measure them there are 21 years old

Aloha from Maui, all that I can find on the part is 17 3 IP... which one should I get?