Viewing all customer Discussions for:

S385-27 27" Series 385 Channel Balance

Could you help identify replacements for this? It's a half inch channel, 27" length. Thanks.

Good afternoon,Could ypu please identify and quote on 6/ea window balancers, ends per the attached photo.They are stamped "26 3" and "RN BSI TJ", the metal section is 27 inches long, and the overall length tip-to-tip of plastic end pieces is 28 inches.Thanks!Paul

Channel balance remains in frame when window closes and sometimes in the bottom of frame when opening window. This causes windows to get stuck and not work properly. I think the springs could be weak and causing the problem. I have 4 windows not working properly. Also I have a need a few take ou ... (cont.)

Hi - I appreciate the help. Need to replace a Milgard balance with stamp 26 5 KM CMC 11. Only one of the two balance parts is stamped but they appear to be the same. I would like to purchase a matching pair even though only one is broken. Thank you.

Could you please help me find a replacement for this window balance? The metal part measures 27 inches. It says "Unique Balance 26B" on it. Thank you, Debra

I send you two pictures with the existing channels removed from my customers window. Both measures 27" long but what strikes me the most was that they have different stamps. The window is approximately 20 lbs and I need to know what to order. Please reply with advise. Thanks

Hi there, I have 2 different sized non-tilting windows with the same type of channel balance that I need to order. Based on the pictures (attached) of the top and shoe plastic fittings I think I have 1/2" Series 380, 27" (metal only measured) channels as follows: 1. Small window with weight of 22. ... (cont.)

Hi, Both of the balances on my window failed and I'm looking for replacements. And want to make sure I get the right stuff. Balance stamped with 26DS 33. Not shown well in the pics, but it has a pulley system and a heavy spring. Please let me know if you need any more info. Thanks! ... (cont.)

Broken window balancer, non tilt window, track channel. Stamped number: 86 26-4 DC5 CMC 45

I need a replacement channel balance. Please respond with correct part number required. It's part of a Milgard Window assembly. Thanks, JT

Hello, I'm looking to replace 3 broken balances. Hope the photos help in identifying the correct part needed. Ernie

I'm needing a couple of new window balances, but these are the only identifying numbers/letters on my current ones. Can't seem to find them online.

What will replace the following broken channel balance? Length: 27 inches Stamp on balance: 26 4 BO Caldwell Width: 9/16 Depth: 9/16

Looking for a replacement. Having a hard time.

86 26-4 KA5 CMC 2

Need (2) replacement window balances. Information I have, Sash weighs 34.4 pounds, metal part of balance is 27 inches long, Back is 1/2 in wide, bottom foot looks to be 1-3/32 inches deep. Number stamped is "86 26-6 HA5 CMC 1" see attached pictures.It looks to me to either be your 27" Series 385 or ... (cont.)

Looking to replace 2 to start.

I have two 27" winged on both ends and non-tilt half inch wide and 9/16" deep block and tackle balancer's. Please help. Thanks,Christopher

Print on old balance is 26-4 GG5 CMC 54 Length is 27 inches Width is .5 inch Looking for the right replacement?

Dear Swisco, I ordered the S385-27 to replace the sash balances on my window. I didn't realize that the plastic catch that pulls down the balances also broke before. Now, I'm looking to replace this part that sides into the window and is held in place by 2 screws. Can I have help in identifying t ... (cont.)