Viewing all customer Discussions for:

82-249 Sliding Glass Door Multi-Point Keeper

Here are the photos. Please let me know if you need more details. Looks like product codes: 82-259 or 82-239, however, it looks like my measurement from each bolt is around 5 3/8 and not 5 5/8. Also the top slope is different.

see attached pics

Hello looking for replacement door handle with lock. Do you sell these?

We need a replacement handle set. The lock broke and we need a whole new unit.The springs are also worn out inside the lock

Tag on door is ALI ADW-8 ASTM 2190-ARG Make date 5/11/2016 The inside handle is broken and needs replacement. Can you identify this part?

I replaced the mortise lock with part 82-265 : Multi-Point Mortise Lock with Face Plate, 11". The lock does not set with the original keeper anymore. I can manipulate the lock to sit on the keeper, but is not very secure. Would I need to also replace the keeper or other issue going on here? I did n ... (cont.)

This is a sliding glass door that was installed 10 years ago. The locking key female end broke apart inside. I need a replacement. Please see following pictures.

See pictures above?that is all I could find.

The lever falls out for locking the door. What part number do you have that would replace this one? I was thinking the 82-030???

Locking mechanism for sliding patio door. Supposed to be Anderson.

Looking for latch and handle assembly for NAMI- 302187 door.

Door came from home depot. no markings on door or parts

I purchased a 82-239 lock in April but had to send it back because it didn't fit. I spoke to costumer service and they suggested I send images of the part in question hoping someone can help me match it for the right one. NNOW what should I try.

Is there a way to buy the whole set handles and all. The door was put in 2007-2008. American restoration setup the installation

guardian. Geneva ny. ansiz97.1-2009 16 CFR1201 II safety tempered SGCC22591/8ua CAN/CCSB-12.1-M. need replacement handle &lock

I just purchased a new lock for my patio door from Swisco. I also need a new faceplate, though (see pictures attached). The locking mechanism is 11 inches tall, but the slot that the faceplate goes in is 12 inches tall.

PAT# 5.820.170PAT# 6.264.252Whole assembly door handle and lock assembly.Marc

Just received my new lock, no problem installing. However the door jam part is not exactly the same fit. Could you please send me the part number for that piece so I can order and replace the jam receiver for this lock. Thanks

The door handle mounting holes are 3 and 15/16 in. The holes for the mechanical insert on the door is 11 in. The mounting holes for the plate on the door wall is 10 inches. Hope that is enough information to identify the parts needed.