Viewing all customer Discussions for:

26-078 LH Top Tilt Latch, 2-5/16"

The dimensions are 3-3/8 x 1-1/4". There is a number on the underside "P51"

No markings on latch

Hi, Can you please provide part number for the attached photo. The locking mechanism for window slash. it is a tilt window. It is broken. I need hala a dozen. Thanks

There are visible distinctions on the windows or the frames available to see and figure out what we have unfortunately.

I'm looking replacement latches. I think they are surface latch replacements about 31/3 inches in length with screw holes (philips head) on both ends.

Looking for replacements both left and right sides

Do you have this black tilt latch in stock 3 and 1/2 in Long by 1 in and 1/4 wide I need between 20 and 40 pieces.

This window is more than 45 years old.

These plastic parts are disintegrating though otherwise windows are ok. I'd been happy to re drill the frames if you had a part that could work but with different screw spacing.

Both left and right Internal tilt latch / lever broken off. Double hung tilt vinyl windows. "Boreal" is stamped on the slider piece on top.

I have channel balances in my aluminum window. The shoe is destroyed. How do I get it out to identify it? And even more important how do I get the new one in?

I need a set of these. Would prefer to have a set without the locking feature and in this same color.

.the distance between the right screw hole and the left one is 2 and one quarter inches (center to center)...

Hi, I was looking for left/right window latches but wanted to confirm I have the right size purchased. Can someone help me identify the correct size latches based on the photos? I would be more than happy to upload additional photo's if necessary. Thank you in advance.

Broken windows latches

3 and 3/8 long and 1 and 1/8 inch wide and about 5/8 inch high.

approx3.5x1.25

Hello, I have a window that has broken balance and latch. I searched the internet for the Mfg. number and found nothing. I could use some help getting the correct parts to replace. Thank you, Steve

The d/g units date from 1984 and the seals are still good. But the plastic fitments on both sides have degraded, split, broken over the years.They might have been intended as a feeble lock but there is a central aluminium catch to secure the upper & lower sashes. The units have been in since the hou ... (cont.)

I have vinyl tilt windows that were installed before I bought my house. Some of them don't work very well, and seem to require some parts replaced. I can't find any markings on them, except for 'INE 96' on the inside of the aluminium part that holds the glass. A websearch for that lead to a forum po ... (cont.)