Viewing all customer Discussions for:

39-387 Split-Arm Operator, Wright

Looking for these

Good morning, I am following up on my phone call this morning with a few photos. I am looking for 2 sets of replacement hinges/arms and locks. These are 25 years old and are Silverline windows from Hurd. Please let me know what else is needed. Regards, I measured one arm at 4 inches and ... (cont.)

Hurd cranks identified by Wright 07900 - I need 2 lefts and 2 rights.

Window was installed in 1992. Number on bottom looks like 7?08 and 07900 on the arm.

This is a Hurd casement window crank. On the back it has 7702 stamped. On the black arm it says Wright on it.

I am looking for a 5" pin to pin straight piece that guides the opening of the window. They are at the top and bottom of the windows. The p/n for the arm is 6492P. It seems to be riveted to the rail that screws to the bottom of the window and has a clip on the window crank side. I have Hurd Casemen ... (cont.)

DO YOU HAVE THIS TYPE OF OPERATOR

Hurd window operators (30 years old) - appears plastic "figure 8" slide pieces are brittle/broken. Need new operators, not sure what model. 6D92P is stamped on the lower arm. 07900 is stamped on the upper arm. need 4 right, 2 left pix attached. thx!

I'm looking for the correct part replacements for a left and right casement window, Since there are two windows side by side, I will need to replace the left and right. Please advise me on part numbers I'll need to order.Thanks,Mike

Not sure of the window nor opening mechanism manufacturer but I need a replacement for the attached pictures. Thank you, Aaron

I need to replace the window crank. The clip is at the bottom, I saw the name "Wright" on one of the parts. I need one for the left and one for the right (two different windows). Will part number 39-317 and 39-318 work?

Looking for two left hand crank left from looking out double casement. hand cranks for Hurd casement windows 1988 cranks only just the section only in picture 07900 Wright. The picture is the of the right. Thanks

I am looking for a dual arm window, crank compatible to the picture shown

Gear to open and close window non functional. The drive shaft is extended out. And not engaging. Two Attached pictures. First is tag on upper inside of opened window casement. The second shows window in open position. The bracket is attached to the window with two screws, and is part of the cra ... (cont.)

Hello, hoping you can identify this window crank. I would need several rights and several lefts. Preferably the same color but does not have to be.

looking for replacements for old Hurd window sill mounted operators. model 55101 and 55100, gold in color.4 3/8" arm and 3 1/2".

I need to Replace these Split arm window operators I'll need 9 Right hand and 6 left hand along with 15 handles. Do you have compatible replacement parts guaranteed to fit. I found part numbers which are 39-317 39-318 and 39-114L for handles will these be the rite ones to replace mine I have shown. ... (cont.)

All of my windows have "play" in them when the are open. The crank will move at least a half a turn before the window moves. I believe I need to replace the full crank hardware. I think I need your 39-387 & 39-388 parts. Could you please confirm for me. I have a total of 17 white I need and 2 b ... (cont.)

Hi I have these incasement windows. I like to find out if you have these or equivalents that I can use to replace couple of them that needs Replacment . Any advice will be appreciate it . Looking forward to your comments . Tks Alex

What colors do these parts come in? I need Bronze