Viewing all customer Discussions for:

81-272 1-1/2" dia Roller And Axle Kit

Help - Can you identify the part from the attached pictures and if yes do you have it in stock? thank you, John

I would like the wheel and the axle. I would like to buy four of each. I just replaced the wheel and it worked well, but I have another door.

I am not a window technician, but it looks like I will need to drive out a pin in the casing/frame to remove this roller. This pin is also the pivot point for the height adjustment. Currently the doors have only 2 rollers per a door, but I am told I can install double rollers in place of the origina ... (cont.)

Sliding glass door roller, steel. 3/4

Looking for a new roller. The door is from the late 60s aluminum sliding door

this is from a 59 year old peachtree door but don't see one like it.

Hi, Looking for two patio roller replacements. Wheel Diameter 1 1/2 in. Housing Length : 2 1/2 in Housing Width: 5/8 in.The Wheel is 1 1/2 in diameter. There are no markings but I have included the pictures. Notice the round tip below the screw.

Hi, I have a Pella 72" x 80" sliding patio door that I bought from Home Depot Canada in 1996, I am looking for replacement rollers for the glass sliding door. Although I have the original receipt, it does not have a part number on it. Are you able to recommend rollers for this door? They are 1 1/2" ... (cont.)

I am looking for 4 door wall rollers that match these pics or ones that will work in place of these.

Patio door roller assembly. The wheel diameter is one and three-quarter inches.The door is presumably from the 70s

I need replacement roller assembly for herculite k sliding door 3/16 tempered. This assembly has small prongs that slide down.

I have a large sliding glass door on my house built in 1957. I'm unable to find a roller assembly that looks close. Can I use 81-272 to retrofit? The existing 1 1/2" nylon wheels are not concave. I assume I can drill out the existing rivets holding the old wheels and use the included axles. My ... (cont.)

HOUSE WAS BUILT IN 1967. ROLLERS ARE GOING BAD FOR THE SECNOD TIME. WAS ABLE TO FIND THEM THE FIRST TIME, BUT NOT NOW. WOULD LIKE TO KNOW IF YOU HAVE ANY ASSEMBLYS , OR JUST THE ROLLERS. THE ROLLERS ARE 1.75 IN DIA. WITH 1/4" HOLE. ON THE ROLLER IT IS PRINTED KILIAN SYRACUSE, NY. ... (cont.)

Hi, My house was built in the early 60's. Attached are 3 different views of the roller assembly. *The metal roller itself had a plastic concave outer piece which has dissintegrated. Can you identify the best replacement part so that I can order some? Thank you Bryan B.

Please help me find a quantity of six rollers like this. Thanks Gary

I need a roller assembly for a 1964 vintage wood patio door. The wheel itself is steel and has a groove in the middle. The part itself measures 3 inches across the top. No markings on it but the handle on the door says Crane. The top part of this roller has 3 holes in it to attach to the b ... (cont.)

Need a replacement roller - wheels are gone! I think the wheel was 1&1/2in. The housing is 1&5/8 in long and 1&1/16in wide and 3/4in thick

I think this is a Peachtree sliding glass door. My rollers have worn out. What rollers would I use as a replacement?

can anyone tell me where to get this roller for a sliding glass patio door?

roller has Saunders Engineering Corp, Miami, FL on one side and the number 8 on the other side. the OD measurement is 1&5/8ths but has a lot of wear and may have started out at 1&11/16