Viewing all customer Discussions for:

39-400 Roto Single Arm Operator, 13-1/2"

Straight arm casement operator

I have a Silverline casement needing an operator. 13" arm, I believe. it has an odd track. Photo enclosed.Thank you!!Wayne

Trying to locate this operator. Not sure if I need one without a cover a need to purchase a cover separately. The one I need is all one piece. The arm measures approximately 13 1/2 inches from the base of operator. Also I added a pic showing how the extended arm is connected to the sash. It has a sw ... (cont.)

an operator -Numbers in black on the back are: OP05-7574-03 11-1-07 82033 also numbers on the medal are OP05-1505 a pin- The numbers are OP051002, Front of Pin appears to be 15/16 at the widest part. The pin inserts into the tract and clips to the arm of the operator.

There are no identification numbers on the crank assembly The measurements are as follows: 1. Hand Crank: 4 inches 2. Short Lever: 6 inches 3. Long Lever: 12 inches straight run(i.e.: before it starts to curve towards window.

Arm measure 13.5 inches. Tenant broke hardware off of window so there may be additional parts not included in the image.

Hello! I am missing some handles and a few of the windows no longer open correctly, so I'll need the whole operator. They are vinyl and once I unscrewed the plate, it just slipped through a slot in the window frame. The measurement from roughly the center of the operator to the center of the hole at ... (cont.)

I am looking for these

Egress casement window operator.

The arm is 13.5 inches from the center of the gears and to the center of the detach clip. The body is 5 inches wide and 2 3/4 inches high There's no numbers or descriptions on the device

Left handed operator. ROTO window Model number HG04 2006U.

Do you think you could help me find this drive arm? I've bought two others but this is a slim-line and I can't seem to find it anywhere. Any help would be greatly appreciated.

Looking for the following roto window hardware. Do you carry any of these? See embedded image. thanks

LH casement (looking from the outside), part# 07-OP06-7532-03, single arm

Opo5-7810 window crank and handle need replacement.

My name is Gene . I'm looking for this item. Thanks The measurement of the arm of my operator is 12". There are no known stamped numbers on the operator. Width of the body 5-1/8"8 installation holes to screw into base Will also need the handles

Part was broken off by renters part number on back is OP05-7533-03 09/18/03 Not sure if I just need arm or need the whole part. Thanks for your help in advance Alan

Window opens from right, swings left. Number on back is OP05-7533-03.

I have an operator with part number 0P06-7533-08 on it. I have seen similar operators on the website but not this one. Production numbers are 10-31-13 133886

Can you match these parts. the handle is broken (no longer fits into the housing) and the rubber connector is missing from the track. I need both a right and a left version for a double casement window.