Viewing all customer Discussions for:

26-412 Flared Pivot Bar, 2-1/2"

Pivot bar 6, 3/4 " interior glazing strip and tilt in latch all for double hungs

The part shown in photo pivotshoe2 broke. The empty portion in privotshoe1 held the broken part. The label on the window is "52-1006-WHT", 13051014, 250411

Need to replace four broken sash, pivot pins

Hello,I have 8 windows, mainly upper windows that parts are broken due to the quality of the parts. The lower sashes have different hinges with a sturdier part and they seem fine. I'm wondering if you have any replacement parts or any direction, advice for me. I do appreciate your time in advance. ... (cont.)

I've attached photos of a part I need for my window. Can you identify it? Thank you!

Hi, Please see attached pictures of the two pivot bars that I am looking for. These are for windows purchased at Home Depot in 2003 or 2004. In the picture you can see that one has a stamped # 1074. Looking at your website ... it seems that Top Sash Pivot Bar, 2-5/16" Product Code: 26-400 is very c ... (cont.)

We are going back a few years here. I need several. Cam locks appear To be ok

Need a retrofitted pivot that will work. Hate to have to replace the whole window for a pivot. Up above you can see the pivot I need along with the existing shoe that the pivot goes into.

I had both pivot bars from an upper sash fail. I am unable to provide exact dimensions because broken pieces were not recovered. I attach a photo of what I was able to recover as well as the screw hole distance from an identical intact window. Also pictured is the label/sticker from one of the windo ... (cont.)

Ellison window series 1500 shoe replacement, for left side and right side. Do you have this replacement part?

Tension springs hinge parts

Broken window clips on 10 windows

This pin snapped while trying to re-install the tilt out vinyl window back into the window frame.

Farley Windows Upper sash pivot pin The total length is 2 1/4" Length from top to 1st hole is 7/8" Length to 2nd hole is 2" This piece is hard plastic. The windows were installed in 2001

1st to pics are pivot bars for top and bottom window. 3rd pic is a screw up and wondering if any way to cover. 4th pic is cover- its hard and brittle do you sell new ones that are a little flexible. Thank you

Maybe part of balance

Hi I would like to replace some broken tilt latches (12 pieces) and pivot bars (12 pieces). I think the tilt latch should be 26-39, but it is discontinued as I checked on the website. So do you have an alternative that I could use? For the pivot bars, I was not able to find a good ones, but I thin ... (cont.)

I am looking for the balancers and footers Need one groove guide ,4 window pins and one upper sash balancer minimum Upper sash balancer he's measuring 25 1/4 and the lower sash balancer measuring 27 on the U channels And there's no identifying information on the sashes or frame to indicate manufactu ... (cont.)

I'm in search of this pivot bar. I have found ones similar but they need to be longer. 2 and 11/16 total length. I have ordered about 7 different kinds with no luck.

Would you be able to match new hardware for two windows based on the photos submitted. Please advise. Window sash weighs approximately 14 lbs. Thank you J