Viewing all customer Discussions for:

26-193 LH Rollyson Tilt Latch, 2-5/8"

The screw holes are 2 1/2" apart. The latch measures 1" X 3 5/8"Which latch should I order?I need approximately 24.The windows go up and down and the latches release and tilt the window so it can be cleaned.

Looking for these parts, pictures attached. I do not know what make of windows these are. The house was built in 1993.

We are looking for the product that the picture is uploaded above. The window is by iwc. One of the part is broken from the right side. Thank you

Help, I need a latch to fit this window. I am looking for the part to go in to hold window. Old parts corroded away.This is a piece of old part. All I need is anything to fit in a 3/4 slot to hold window.

Please help me find replacement corner latches in photos, also a part that is located on each bottom corner of the upper sash (photo), possibly a dust plug 26-091? The part helps pull the sashes together when closed and locked.

This is to ask you to please help me find replacement tilt latches for my aluminum Home Craftsman windows by Ply Gem. Ply Gem no longer carries these parts. I contacted them and they suggested I contact you. These windows were installed in my house before I bought it in 1989. Across the top, as y ... (cont.)

These parts slide into the track to hold the window in place

I plan on replacing broken internal latch with surface mounted latch and looks like this model is best fit 26-193. I am concerned 3/4 inch screws will be too long for my very thin sash. What model/brand/size shorter than 3/4 screws do you recommend to go with 26-193 latch?

Manufacturer is out of business, cannot find replacement part.

Searching for this TAN surface mount tilt latch. The screw holes are 2 9/16" centered. The width of the latch is 7/8" Are you able to provide this part?

do you have this type of window latch? the window thickness is 15/16th Armored Knight is the name on the window. Scott

Ithe windows do not have a name on them Need 2

there are 4 on each window 2 on the top and 2 on the bottom

I need 26-372 If you can find a substitute we'd be mighty grateful.

This is a internal latch. If can not match maybe have something close in size and mount externally on top of window?? Thanks Dominic

I need a left and right side window lock guide. It says Stipulates Conformance is the manufacturer. Vinyl Window. Has two screw hole on top.screw holes from center to center are close to 2 1/2 inches.

Hi- this is an exterior corner tilt latch for the windows in my house. The only info on the windows is the window lock says "KoolVent" I have not been able to find replacement latches like these anywhere. Hoping you can help!

I need replacement tilt window latches (both left and right) for Imperial aluminum frame windows (photos attached). I couldn't find any names or numbers on the broken latches. I have several windows so I would need 3 left and 3 right latches. Let me know if you need any additional information. Than ... (cont.)

I need to replace the lock and interior latch. The lock is 2 7/8" x 7/8" possibly 3/4" The latch is 3 1/2" x 7/8". The label was on the of the window

Need 6 of these, please provide part number to order. Is there any other hardware that I will need?