Viewing all customer Discussions for:

26-244 Tilt Window Latch, Right Hand

Im looking to get new latches for tilt window. I believe these are Farley windows. Any idea as to what part number i need to order?

Single hung Simonton windows in my house are from 2004. Some of the windows are very hard to close. Some of the latches on top of the windows have also broken. Which teed spring do I need for replacement. I have attached a picture of the label of the window, teed spring and latch. ... (cont.)

Hi,I hope you can tell me which parts I can buy to repair my windows. I need a latch, tilt coil springs and the white plastic parts that is in the picture # 1627.Thank you for your answer.Anne

Looking for parts for Rivco Town & country left and right tilt latch and two balance clutch shoes.

Need correct coil balance shoe and Pivot bar that goes to it Also both left and right latch

Trying to repair a window that won't open. I toom the window out of the track and slipped it back into the horse shoe part. But the spring in the plastic is broken or unable to work properly.

Hello we have 2 large Midgard windows that need all new bakancers and shoes, 3 springs each at 9lbs we were told. 1 window needs a new tilt and pivot bar. We watched the video and don't want to cut the vinyl to remove and install the new balancers is there a special tool that can spread the chan ... (cont.)

House was built in 2006. Right tilt latch has broken and needs to be replaced

I have a double pane hung window. Couldn't not get window shut. Then top window dropped down and will not stay in place. On bottoms window, this part is broken. Thanks

Pic 1020 is the working left side. 1019 is the broken right side 1021 is the broken parts

My windows are almost 30 years old. All that sun finally has caused many of the latches to break. I purchased latches from another vendor before I found you, and they are exactly the right size, BUT the latch part extends beyond the frame of the latch ( on the side facing into the room) and it needs ... (cont.)

I'm looking for replacement tilt latches for my windows. I saw that you recommended 26-243 and 26-244 for a similar post. My concern is that the smaller portion of the triangular latch piece, listed at 3/8" in your diagram, is smaller than what I measure mine at (13/32"). The difference is minor, bu ... (cont.)

Hello, I was cleaning windows today and both of the levers you pull to be able to lean the window out clean broke off. With the picture I sent in, this is the only numbers or letters on it. Pat #5.39.29 and the other number 075. I would need a left and right one. It does slide out of the window. Tha ... (cont.)

Need two sets of left and right

Need four.

Hi I need both Right and Left. Just want to make sure i get the right onestop 2.70 x .73Bottom 2.62 x .58thickness .42Thank You Tedd

I need a left and right tilt clip for a window.

We have an unbranded window with a broken top/ right side latch. I did not see any that looked 100% similar but perhaps one can be good enough to work? thanks

Windows vinyl tilt latch

10F is probably the die number, and the patent #5,139,291.It also has a sizing of .092.Needing the left and right of this style