Viewing all customer Discussions for:

26-244 Tilt Window Latch, Right Hand

Made circa 1984. Part is displaying Patent # 5.139.291 Please help. Thanks,Jimmy

I need to replace off white tilt window latch.

Team,I'm in need of the following parts: Tilt Latches (PAT. #5,139,291. 7b), both left and right and Coil Balancers (Not able to find a part no.). The windows were installed over 20 years ago and I am not able to identify the manufacturer. The following information appeared on label attached to uppe ... (cont.)

This holds the window in but unclips when you want to clean the outside so you can tip it in. I call it a tip in window clip but your software gives me discussion boards to read instead of a part. Apparently I don't know what they are called.

Looking for Reliabilt parts left and right, tilt latches series 3201 several

Man of our window latches have broken. I need to replace both left and right window latches. Please advise which latch would be a good replacement for what we currently have.

Looking for these flush mount, push in style window tilt locks. Thank you!

Need lefts and rights

We have to replace a number of tilt latches and require two different styles. Pictued is one style we need pictue 2855shows latch top of latch. picture 28854 shows bottom of latch with a patent number and a N probably manufacturer code? This latch was easily removed by using a flat blade screwdrive ... (cont.)

Looking for two rights and two left Top Measure 2 3/4 Long Wide 5/8 Deep 3/8

Please find attached pictures of my broken latch. It is the 2nd picture and it is the right side of the window as looking from the inside of the house. Jeldwen Windows There is a tag on the frame of the window and it has these part numbers on it: H-R25-48x77 & H-R40 ? 42 x 60

Can you help identify this internal tilting window latch. It measures 2 5/8" long (actual length without latch extended) by 11/16" wide

I'm going to need a minimum of 10 but I would like 4 more as spares.

I think this is a snap-in latch but it slides in easily as well. I cannot find a name on the windows. Our house was built in 2005.

I think these window tilt controls need to be replaced as the plastic has become brittle. The tab on the left has snapped off. The right was still intact when the picture was taken. Do you know if your parts fit alenco?)

Left and Right tilt latch for Ryan Homes single family residence built in 2008. 3" long overall, 3/4" wide, 3/8" nose. Clear plastic underside. No full lip under the top plate, and a full lip replacement doesn't fit in, either. No markings other than L and R. The left one snapped in two and th ... (cont.)

Looking for 3 left and 3rt hand hatches.

Would you be able to identify and give me a part number of this release latch.

Hi,My name is Pete Patnode and I am looking to fix several windows in a house my son just purchased. I think these parts are called sliding window guides (photos 2, 3, 4) but I cannot find the exact match on your website. I am not able to determine how old the windows are or what brand they are. ... (cont.)

Hi there, i am trying to replace the tilt latch shown in the attached files please. Would you be kind enough to assist with a replacement please? Regards (Suggested 26-345) Thanks for your response. Please do you have those measurements in cm? from my current comparison yours seem longer than t ... (cont.)