Viewing all customer Discussions for:

82-080 Mortise Style Handle Set, 4-15/16"

Hi My handle broke in two. on the door the only thing I see is novatech ste-julie 2005.

dear madam or sir, Could you figure out based on the attached pics the replacement hardware needed? The lock is now stuck in a shut position and I can no longer operate that lock - likely I have to bore it open to remove the internals, open the door and replace the lock. Please let me know what yo ... (cont.)

Side screws are 4 7/8 inches apart

I need to replace this. It broke

An interior part of this door latch for my sliding glass door has snapped. Do you sell a replacement for this off-white handle?

Need new handle

Distinct markings are in the photo I believe the first photo my understanding from a little bit of research as this is made by Certain teed? Please contact me at my email address below as I will probably not be able to find the post

Some broken parts

Made in 2004. It's 7 inches long and probably an darker then an almond color. I need to buy a replacement handle

Hi. yours was the only company that came up when I tried to search for this model number. This 6' sliding door is about 20 years old and the hardware doesn't lock. I'd like to get new hardware. Thanks, Michael

Have a patio door handle that actuates to open the door. There is a faceplate on the inside of the door with a wheel with gears on it that are mostly missing so no longer functional. Do not see anything similar on your site.

Need the handle replacement with a key to open the impact window sliding door

Hi - I have a heavy duty lockset that goes to my slider, but the handle broke. I am trying to find a replacement for it. The lockset has no manufacturer or part number on it. It has a double hook connection (see slots on last picture) that latches to the door frame. I would appreciate your help i ... (cont.)

Hello, Can you please tell me what mortise lock, I need including the model number? One hook will not work when you move latch, only moves by hand. I believe it's a Millard sliding door. Because of the logo on the handle. However, there is not a cover plate around the mortise lock either on frame ... (cont.)

Hello, please help me with identifying the right handle with key to lock this door from the outside.

We would like to convert this handle to a keyed entry, it's 4 3/4" from center to center on the screws for the handle

I am trying to replace a broken handle on my slider. The door apparently isnt standard as the replacements that I find do not match the mounting holes. This unit has a 5" mounting hole spread as shown in the picture. it is the interior handle portion and as seen in the picture, the mounts snapped. ... (cont.)

Below is what is stamped on the door: GuardianANSI z97.1-2004 16cfr1201II SGCC9681/8ua Can/00s5-121-m

My current lock automatically locks when door is closed from outside. Thus I could get locked out.The sliding door is 1and 1/2 inch thick and the slot where the lock sits is almost 6 inch length what is the part # I should order to replace the current lock. Do yo provide any instructions to replace ... (cont.)

Question: Until 89-036 is restocked, On the slider that is broken, it's a like a 2-way slider, the slider with the attachment that's broken is on the right hand side and you push it and it goes to the left, the slider on the left, those locks are in tact, and pushes to the right. We can put a stick ... (cont.)