Viewing all customer Discussions for:

82-086 Legacy Keyed Handle Set, 3-15/16" (1-1/8" to 2-1/2")

I'm looking for a replacement door lock with a keyed entry for the Jeldwen 4500 series sliding patio door.

This a Ply Gem slider 5800 series purchased about 3 and a half years ago at Lowe's. The inside handle cracked by the lower screw.

I do not see any manufacture name anywhere on my door, handle or lock. I think it looks like your part 82-265. Can you help confirm. If this is the right part can you confirm if handle 82-086 works with that lock? It also looks like my handle. Thank you

Pictured plate is 12.5" tall X 1" wide. There are no visible numbers or brand markings.

Do you think product 82-086 would be a replacement? Measurements seem to be good. Thanks,diane

I'm looking for a replacement handle for our sliding patio door (SGD-R35-71x80). It is a keyed handle with a 2-catch mortise lock. Will 82-086 work? The measurements of the handle are correct (ours is longer--9 5/8"--but the holes are in the right places, the width is correct, and the stile is 1 3 ... (cont.)

No markings on existing hardware other than its Guardian Sliding glass door.I would like to know what handle/lock i need to replace with since the lock is not catching when I go to lock the door. Or do I just need to order that middle locking piece. Help a single woman!

Looking to replace my door handle my key is lost and need to replace the handle now. Looking for exact handle that will fit my door.

Good afternoon, I made a purchase of sliding glass door handle a few weeks ago. I went to install it today and while it seems like it should fit it doesn't. I'm enclosing some pictures of both the old handle and the new handle. The old handle is the white one. The tail ends that go into the actual ... (cont.)

The white switch that we use to lock fell off. We would stick it back on to lock and unlock but it keeps falling off. We attempted to put it back together but now a lot of pieces are off. Please advise Gina

Single lock

Lock seemed to break and got stuck in locked position. No markings on any part of this assembly. Looks like a multi point lock but only utilizing one lock?

I need the interior part and the handle.

I have a Semco slider with a polished brass handle and would like to change it to oil rubbed bronze finish. I have attached a photos below but the screw spacing looks to be 3-15/16. The door is 1-3/4 thick. Thanks in advance!

Hi. Needed to order the parts for my sliding door. Can you advise which products I need to order?

Door lock is broken. Stuck in lock position

Hi I need to replace my handle

Looks like the one I ordered except 8 inches handle screw to handle screw. Mine is not keyed, but I'd like it to be.

Can I replace a handle that doesn't have a keyed lock for a handle that does have a keyed lock on my 6' Guardian slide

Good morning.Please see the attached photo.Can you assist - looking for qty of 1Every good thoughtErnest