Viewing all customer Discussions for:

36-048 2-Bar Hinge Set, 10"

I need for the left and right hinge

There is one at top and one at bottom of Truth Casement Window

Need new crank. it has part numbers: 45135 crank body 40352 arm 20810A extension

I need a left and right casing the whole assembly.

i would like a replacement slider. it seemed to have split and a portion missing. it will not stay in the track causing bottom corner to pull awAy from the seal

I'm not sure if these are left or right handed but these are the parts we need if you can tell in the photo which hand they are.

Number on part 605

Arm is 12 inch. Condo built in 1984 Left hinge

Hi, I am replacing two Truth casement operators. One is a dual-arm operator (39-02); the other is a single-arm operator (39-06). Before I ordered them, I wante do make sure that I am ordering the right parts. I attached a few pictures of the current operators. I would appreciate your advice. Tha ... (cont.)

I ran into the open casement window while mowing lawn with my John Deere lawn tractor, the bagger caught the window, and has bent the mechanism. I was able to close the window by pushing it closed from the outside, but the window is not at all usable. A gap now exists on the lower half of the wind ... (cont.)

Main arm about 9". Track on window about 11 1/4". can you identify now or do i need the hardware off picture

Truth Entry Gard Window operator Hinge on right I need two

I need a replacement operator for a 30 year old Weather Shield casement window. I checked with Weather Shield and, they longer carry this replacement, and was given Swisco as a third party supplier. As can be seen in the photo the Part No. stamped on the arm is 31850. It appears your Truth Dyad O ... (cont.)

The only markings I can find is on the casement operator-0P051507

I have the same problem as another customer. My window on the swinging outside edge sags and has to be picked up to close. I do not have that cool milgard adjustment screw that youtube says is used to adjust. Building built around 2006. The material hinges appear to be weak and have a lot of fle ... (cont.)

These locking mechs and rolling armatures need replacing. Trying to identify correctly. Pretty sure it's a Swisco window.

48x48 window with a 16 x 45 " crankout windowOpener - Entrygard 31539Bottom track 40941Latch 21088Lock no numbers Need all new hardware

I need a replacement for the black piece that attaches to the bottom of the window and slides under the rail as the window is cranked open.

Casement pivot point broken on the track that is attached to the frame

I need this part for an Okna window