Viewing all customer Discussions for:

36-048 2-Bar Hinge Set, 10"

Hopefully the pictures say it all - I see a brand name of Vetter but no part numbers

Hello Please see attached window hardware photos I have some photos with the damaged hardware on the window and after I removed it , im looking at replacing the following: 1.Complete window awning hardware , found matches part # 39-239C 2. Track, found part # 39-556 not sure if it’s the ... (cont.)

Need help with part number for the 2 pictures below. 2 different size window

I'm guessing that the originals are no longer manufactured. It looks like there are a few possible options on your wesbite, but hard to tell which would work if at all

I need replacement hinges for a Truth casement window. House was built in 1986 and I suspect these windows were part of the original construction. I don't see any hinge hardware that has the dogleg angle to it as seen in the photos. Full window size is 34" width, but there are two windows in that sp ... (cont.)

I need to find the upper and lower hinge assembly

Hi need casement window crank

Looking to find a replacement part for the broken hinge (the black plastic part has snapped in half) on our peechtree window. I also have a picture of the date/information code that is inside the glass if that is needed. If you need any more information please dont hessistate to ask. thanks bill ... (cont.)

Crank pulled out of the window crank of our small kitchen windows above the sink. Arms are labeled entry guard truth, and the two arms are roughly 7.5" when full extended.

I need these parts

I have 3 pairs of casement windows so I would need 3 right hand and 3 left hand hinges

Do you have pairs of hinge arms that have a sash clip on end that attaches to the track? My windows are Biltbest Casements 1987. The sash tracks are built into the windows and go all along the width of the window.

Hello, I need a new operator and hinge

This short arm attaches to the main longer crankout window arm on the bottom of window.

Not sure which series windows, since there are no stickers or codes anywere. I uploaded all parts, I have several windows. All very hard to open and close, house located off the dock so sea air and several years of no maintanance have made very hard to use.

Please can you help with finding a replacement for this crank

Hello, Would appreciate the help. From searching around I believe these are truth window hardware. Needing to replace a lock, operator, bracket that the operator attachs to on the window, and the piece that connects the window to the rail that slides back and forth in the rail groove. 1) Casement Lo ... (cont.)

I have a right and left opening window that the hinges and cranks are broken.I also need a few of just the non folding cranks.Please advise from my photos.Thank you

The windows are hard t open, house sits off the ocean water, so could be the salt in the air, affected the operation, especially since previous owners didnt maintain the windows

Hi, I'm looking for the correct part to replace on this bay window with 18in casement. The crank arm pin rivit rusted. Thank you, Brian