Viewing all customer Discussions for:

33-016 #8 x 1" SS Installation Screw

The attached photos are for an operator on a Marvin window that a Truth motor broke -- the crank was broken out of its socket. It has two 8-inch arms, and appears to be EntryGard brand.

Truth right hand three part arm replacement for window. Or at least which type of screws needed for the 3 screws to fasten to window?

The only number I see is PAT. # 5.737.877. Spring assembly is 29 inches long. Window is 29 wide x 59 high. The only marking on the window is MW on the latch.

Looking for replacements in white purchased truth 31300H from swisco but they are not right fit

It's a Milgaurd window the crank broke and I'm trying to find the right part

Window weighs 16.5 lbs

The only numbers I can locate on it are: 041007 0019M I have also attached a picture of the operator. It is a casement window that opens to the outside and the dimensions of the window are 29.250X20.750. The operator is seated in the middle of the sash.

Looking to replace Truth Casement window operator, handle, covers and brackets. The attached picture is the part(s) I am trying to match. I need a total of 7 sets (L & R) assemblies (total of 14 assemblies). I am also purchasing replacement stainless steel screws. I believe the Swisco P/Ns ar ... (cont.)

need to buy this part

Needing whole operating assembly kit. Handle, crank, arms, fasteners, sliders and mounting screws

See photo for pat number on window balance. Looking for replacement window balance parts. Mostly top plastic clips are broken.

Need to replace my tilt windows balances balances. The length is 28". I took a pic of markings. (11/2) UNIQUE 27-F-60. Do the numbers refer to the weight load.

Hello, I need a replacement for this balance, thank you.

I just replaced all 4 spiral springs balances measuring 27 x 5/8. I charged the springs with 12 turns on each side, but the top window wants to slide down 1/2 inch to an inch no matter what I do. I can't tighten the balance anymore or I won't be able to get the window up or down. Not sure what I ... (cont.)

Hello, I have two casement windows and they are the same. Very rusted and I would like to replace hardware. Do you have parts and is it a DYI (I watched a few vids).

Need to replace to window balancer. I took pictures of the adjacent window that is identical.

I need the following four- 19" twist balances 40 - 27" twist balances

Do you have this balance it's a m&w double hung window the balance measure 31"

Good morning. I need to replace these items on our windows. Home built in 1999. The length of this is 32" which I measured per your website's instructions. The tip of the support is white (best I can tell) and the diameter (plastic sheath) is shown above. I believe it is 3/8"I believe I would ne ... (cont.)

Hello! I need help identifying some replacement parts for the windows in my home, specifically the pivot/balance shoes and tilt latches. These are for Pella vinyl double hung windows manufactured around 2007. The pivot/balance shoe has number 4610108 stamped on it along with PAT number 6,679,000. T ... (cont.)