Viewing all customer Discussions for:

39-002 Window Crank Operator, 9"

Hi. We are a nonprofit restoring a 1947 home in Austin TX. We have several window mechanisms that don't work & some broken handles. Can you help identify replacement parts. There are no identifying markings on the top, sides or bottom. Just a "1" underneath. Thanks.

Please help us in identifying this part. Thanks

Crank has number 250-32 You have to push the window out about 8 inches for the crank to engage We have 5 windows

We are using casement windows that came out of a warehouse years ago. Bought them from a architectural salvage company in Dallas. Let me know if you have replacement parts. I can also send pictures of the windows themselves if needed. Thanks! I'm not the one doing the work. Have a couple of guys do ... (cont.)

ok

We are looking for replacement cranks for these 1943 metal casement windows. Thank you. Leslie

Casement Window Operator. How do you tell the Right hand from Left hand. Thanks John

I have included 3 photos. Please tell me what the correct pieces are.

I measured the single arm from screw hole to tip at 8 and 3/4 inches, exterior measures 5 and 1/4 inches, exterior holes are 4 and 3/4 and interior holes are 3 and 7/8 inches. I thought maybe your part # 39-001 might work. Thank you for your help.

Good Afternoon, Attached are pictures of some old steel windows in the Cottage building at the River Hills project. Do you know what window openers, locks, etc might work for these windows? Please let me know. Thanks!

Please help me identify this casement opener. thanks, mike

To Whom It May Concern:I have 16 properties that have these types of operators and I need to make them operational. NOt all properties are the same but we can begin here.Typical operators throughout house in bad condition. If you can identify this part I will send you quantities of left and right.Ca ... (cont.)

Hello, Can you please help me identify a replacement for hardware shown in photo attached? I believe the stamp says 1.H. I.R. The arm length is 9 inches and the bolt holes are 4" on center.

Hi, I am wondering if there is a way to replace a 9" single arm operator on an old steel casement window to one that opens more than 90 degrees. Thanks, Augie

I just bought an older house and all windows have this kind of opener. None of them work. Do you have this or a replacement that could fit? Thank you

Right and left hand window crank

I had originally ordered 39-001 and 39-002, but the arm angle is not correct as a replacement. These are 9" crank operators. Any assist would be appreciated. I need both left and right hand versions. Thanks, Marty

Attached is a picture of the right side window crank assembly I would like to replace.I need both the left and right side assemblies. Do you have these parts? I could come to Camdenif necessary, but maybe you can identify it.Gary

I am helping do some repairs at a non profit transitional living facility for homeless families. This facility used to be an old hotel. There are several window operators and latches that do not work. Attached are pictures of the a right side operator and a right side latch (both side latches may be ... (cont.)

I haven't seen a casement lock yet here with these dimension. Mounting screws 2 5/8" Gap between mount and lock point is 1/2" to 5/8" depending on where you measure it on the taper. Cranks 39-002 and 39-001 fit these windows perfectly, but I suspect that's rather standard?