Viewing all customer Discussions for:

39-036 Truth Hardware Entrygard Dyad Window Operator

I am looking for replacement crank mechanisms for Marvin casements. The one labeled Living Rm is for a 14" sash and the number is 30842R. The one labeled Guest Rm is for a 30" sash and the number is L30841. Do you have new mechanisms that will work in these windows.Roger

Hinge & operator for Caradco window

Hi, need your help in finding the casement window crank operator. Thank you

Truth and Entry Guard are engraved names on the hardware.

Window hinge rusted through

Truth Made in USA 30830 30841L 30843L 20810 86

Hello I am looking for a truth entryguard window operator with. 6 inch arm not the 4.5 . Do you sell this?

Mechanism in window 5 inches wide, cover 5 1\4, crank handle 4 1\2 inches long according to how you measure from end of shaft to tip, and 2 inches high mid shaft to bottom of handle. Also shown mechanism on opposite side intact. Label on mechanism manufacturer name Truth.

I need the Correct part to replace.

The geared arm is 3 1/2" from center to tip. The clip arm is 4 7/16" The only marking are Truth and patent # 4 241.541 Patent 1982

We have a stripped/cracked Caradco bathroom window opener. The window measures ~ 12.5" W x 31" L. Since we are unable to open the window, we are unable to see any numbers, etc. We did find the word TRUTH as shown in picture above. Any help would greatly be appreciated. Please let me know what oth ... (cont.)

I have a broken operator. Photos attached. Can you match this?Tom

I have two right hand opening windows that cannot be opened with the crank because the mechanism does not work. Ithey are truth products

Pic is of left handle but it is the right one I need to replace. Stamped with truth entrygard. Do you have this one?

I have two Pozzi casement windows (approximately 15" W x 37" H) that are 18-20 years old. I need to replace the hardware; one window won't open & I fear the hardware is going on the 2nd one (I hesitate to open again but may be able to if I need to measure parts of the hardware). It's more in the 'ge ... (cont.)

We have a left and right entry gard truth crank mechanisms. Part no. 4.840.075. There's also another number near the gear, 31782L. If you flip the mechanism there are two additional numbers on the back of the pivot arm; 31368 and well as 20810.

We have replaced all of the operators in our home using part numbers 39-032 and 39-031 but this one is a different window size and the crank is in the middle of the window. Can you help determine the arm operator needed? Thank you

I'm sending pictures per your request to see if you can match a crank up for our windows. Need a left and right hand if available that will match up. All measurements and part numbers are listed for the windows in attached ipicture.. Let me know if you can match the crack and covers for both sides. ... (cont.)

Looking to change out the crank assembly so the window will close easily again.

I'm looking to have this whole mechanism replaced. The whole crank does not work. The brand is Truth. Some of the numbers on the parts of the mechanism are 30830, R30842.Thank you!