Viewing all customer Discussions for:

Door & Window

We are looking for a replacement part for J23 5#27 9-85 Can you please tell us what we need?

I'm in need of this channel balancer

Good morning. I am looking for pivot shoe and spring replacements for the above window, the springs have broken. The units measure 2 5/16" tall, 1 1/4" wide and 9/16" deep. The 28"X18" sach is stamped '7' on the unit and the 32"x22" sach is stamped '8'. I will need 5 sets of the #7's and 2 of the #7 ... (cont.)

screw holes are 2 inch centers

I have a pair of awning windows that won't open because of a subsequent installation of hot water baseboard heating that blocks the Lever. Is there an alternative operator I could replace them with, either a crank or offset lever? I broke the lever trying to bend it enough to clear the heating cove ... (cont.)

No numbers on assembly found only have measurements . One noted item is the roller height adjustment screw is located on the top and the screw that fastens the roller assembly is the bottom screw. Would like to get replacement roller set for this door. Door is located in Lexington Kentucky at my ... (cont.)

Hi I need to replace operator hardware. Markings have a Truth stamp with 30842 R & 30842 L. Please let me know which of your models are a good replacement for this. Cheers!

Crank mechanism for window

Hi. I need to replace the entire arm. Can you help tell me what part I need? Silverline Window. Thanks

I have Simonton Windows, installed 2010. The bathroom/shower window has rusted and broken at the stud mounted underneath the window. It is a snap stud, but the stud has rusted into the articulating arm of the crank operator, and sheared off due to corrosion and torque. I replaced the actual crank h ... (cont.)

35 inch long metal piece. Stamp says 3450 39. One channel balance on each side of the window. As the pic shows.Can you help me figure out the replacement part number?The handyman couldn't find two balances exact the same, and he said one of them didn't have enough strength for our window. So probabl ... (cont.)

Plastic wheels for top of gliding door panel patio

Does it matter if the handle pulls from the left or the right?

I am looking for the Anlin pivot bars tilt window replacements. Here are the broken pivot bars with the measurement and the spring balancer pictures. Is your 26-415 3" Tilt Window Sash Pivot pin works? Thks.

The attached photo is of a broken sash lift. Rhhe part broke at the top where the s Hole for the screw is. I don't know the make but they look like Pella Can you identify the part? Is it universal or is there left and right versions? Thanks

The handle to the hardware on the side, as shown in the photo, broke, meaning the window won't open since the handle is no longer connected to the channel. Anything you can advise is greatly appreciated! Thank you!

The photo shows my existing operator has three screws aligned with the geared pivot point plus two more screws on a smaller centerline toward the external side of the window. All replacement operators I see have a different mounting screw arrangement with two unaligned mounting screws with smaller ... (cont.)

These have 7/18 wheels On mi aluminum sliding window I think 818 series

I have an awning window and the bracket at the end of the window operator has broken. It curves/hooks over the metal bar attached to the window and slides on the bar to pull/push the window closed/open. Just need the bracket not a whole new window operator.

I am trying to replace the cranks in my windows. You guys were very helpful trying to identify the parts. I did not compleate the job as I have so many projects on this new/old house I moved into. I think the parts I bought are not the right ones. I was able to pull the whole thing out and see there ... (cont.)