Viewing all customer Discussions for:

Door & Window

Hello I am looking for some guidance on what I need to replace so that my casement window will close. The crank works fine opening the window (top hinged dual arm) but spins back out of the base when attempting to close. It looks as if the retaining nut has stripped out the crank case. I have a ... (cont.)

Help! Hard to find part. Problem is I need the slotted latch hole to be 1/8" to the right from most locks manufactured today. Thank you for searching for me!

I'm looking for a replacement for an Amerock cabinet hinge. I believe it is an AMEROCK 2010-2, 35mm 105 Degree, 7/16" Overlay Cabinet Hinge,06U. I need 27 of them. Can you help me out.

Door from 1970s I think

Need some help identifying replacement parts for my windows.

Looking to replace Marvin folding crank handle for casement window - white. I believe the Marvin part # is 10898292

I'm looking for this screen stop. it snaps into side jams. Which allows the screen to sit against flange to keep bugs, etc. from entering the house

Can anybody tell me where I can find this part it's for a bathroom bay window the socket is stripped

I just bought an older house and need to replace two broken balances. The numbers on them are: 1.) D12 7427 (or 7#27) 5 84 and 2.) P69 12L 6 84 What replacement balances do I need? Thank you.

hi, I am looking for replacement of spiral balances 30" x 5/8" for a sash window which weight is 48lb. Please let me know which model can be used as replacement, it's price and shipping to FL delivery time. Thanks. David

Hi, I am re-glazing industrial steel windows using 1/4" thick glass. I think I should use commercial-grade steel glazing clips. I understand that the residential ones have a wire strength of 18 gauge, the commercial ones around 16. Do you also carry the commercial variety? I would probably need a bo ... (cont.)

The windows were installed in 2003, when the house was built. I need at least four, and would buy some extras for our other windows.

How to figure the length of shaft on the key lock so is not to cut of to much and not fit in the mortise

Looking for something that will work. It's 3/16 up to the little notch.

Looking for replacement rollers for my glass sliding patio door. Unsure of make or model of the door. Attached is pictures of the roller. It has 2 along the bottom, none at the top. Thank you for any information.

I ordered sets of locks and keepers because we had old locks and keepers that were sticky and wouldn't close correctly. I replaced all of the locks and keepers with this product and it worked great on all of the other windows! I'm having trouble with this lock and keeper not lining up. I've clean ... (cont.)

Need 2 replacement rollers

Do you have a 28 inch long 3/8 inch wide black bushing tilt window Balance

I need to replace about 10 of this locking mechanism.May be you can help me.TY Michael

Good Day -I have approximately 16 vinyl windows in my home that need to have both balancers replaced in each window. The window sizes are 82 inch tall by 35 inch wide inside of window casing dimensions. The windows are approximately 20 yrs old as the original windows on the house. We do not know the ... (cont.)