Viewing all customer Discussions for:

Door & Window

I am looking for this part. It seems to keep the window from falling back down. Thank you.

Do you have anything similar to your 81-228 with a nylon roller with a stainless steel ball bearing? (Ideally with a 1/4" Shaft)

Thank you for your guidance.

This block attaches the front end of a euro-style drawer slide to the front of a face-frame cabinet. It has no numbers, names or markings. It is about 1.3 inches thick at the deepest point. The back of the block atteches to the side of the cabinet and the front edge (where the slide attaches) is flu ... (cont.)

Greetings. Please find four enclosed photos of a casement window that we are no longer able to open or close. One photo shows the "pin" (for lack of the technical term) that connects the crank arm to the rest of the mechanism; it no longer stays in place when cranking the window is attempted. If we ... (cont.)

Will your 40-049 complete lock set fit a chamber door century series?

I have quite a few broken plastic covers on my window cranks. Inside the cover says Truth (see photos. I would like to replace cranks because a lot are broken and also to have a lower profile. I have attached pictures that show what it looks like and the inside. which crank should I order. ... (cont.)

Aluminum windows installed in 2001 built Florida home.

Windows I need them for is 24"x36" and 34"x34"

Not sure of the window manufacturer. There is an rating/listing label in the window track, it refers to a part number beginning with H-LC30XXXXX. I can send more photos if needed.

Hello, I was wondering if I can get some assistance in locating a replacement part of my Pella screen windows? They were installed in 2009. Thank you, Joe Probus

Tilt latch 1 1/2" long and 3/4" wide(white)Picture is top of lower window that tilts down and one switch on each side.

27 in, 2640 stamp, need 2 total. The string broke on both and we need new takeout clips too.

Looking for pivot bar replacement. No markings. Window might be American Craftsman? (Maybe not though.). Any help appreciated!

8 inch at the window frame mount with the words " interlock' and the number 12C-IS23 GT.

We are needing the Tilt in latches for 3 windows left and right. We also need the sash balancer 28" long. Along with the locking mechanism for the balancer left and right.

So I am needing to get some of these latches. I have marked these RH & LH but they look identical and think they could mount on either side. I also want to get some springs which are about 1-1/4" long and about 1/8" OD round . These widows are mounted over the original wood windows. Hope you can he ... (cont.)

Channel length: 27 5/8 in Channel width: 1/2 in Unknown manufacturer Home built in 2011 Balancers needed: 8

I have a customer who's tenet threw away the bottom Patriot sash with grids in it ,the house is about 25 years old ,where do you think I can get a replacement sash.Thank You Glenn Jackson

customer is needing this latch, can you help?