Viewing all customer Discussions for:

Door & Window

I need two new channel balances They are for a vinyl single hung window. I have attached 4 pictures of old channel balances Which are 27 inches long. The window weighs approximately 18 pounds. Thanks!

Hiii , im looking for a replacement lock stamped CD442 , could you please let me know what are my options, if there are any reps in Calgary Alberta i can go see and get a replacement or does it have to be done via transport.Thank you kindlyTudor

Hello, Need help locating replacement keyed locking door handle and double mortise replacements for my PGT slider. See attached pics for more info. Thank you!

Previously purchased this but can't seem to find them. There is a similar one 15-192 ? will this fit?

Hello, I'm wondering what tilt bar and latch would be compatible with this window to make it functional again. Are there any other missing parts of the mechanism? Thank you. It is a pella window.

Hello Swisco Team, I need some help with a replacement lock set for my sreen/security door. I am attaching 3 pictures; unfortunately I was not able to mark them up with the measurement, so here they are: Opening in the screen door for the body of the lock to fit in: 8 1/8th inches by 3/4 inch Bod ... (cont.)

Keeper Front Mount measurements

Looking for lockset for a Larson door, Model 296-SX, Reg# 023631U.231030603.

Trying to locate this style of glazing material vinyl

Hi, I have about 18 windows that needs to be resealed and replace the tilt block and tackle. I have read a lot of posts and watched some videos and I believe that my windows internal parts are swisco. One of the videos you guys presented onto how to repair the window balance, you guys showed th ... (cont.)

Hi! I'm not the original poster but I'm also looking for a replacement of this part. I've attached a photo, the tongue is roughly 3/8s of an inch high and 3/4 of an inch wide. The screws you can see are 2 & 1/4 inches apart, the broken latch still has screws that are tricky to access/measure, but se ... (cont.)

My name is Paul, and while opening our window I noticed the extending arm was all rusted out. The window came out of its track, but I was able to get the window back in the frame and lock it in place. I have attached a picture of the window on the left to show the mechanism as well as several produ ... (cont.)

I am trying to replace my patio sliding door handle and lock with one that is compatible. It is a Guardian model sliding door. Model ANSI- Z97.1-2105. It needs to match the current set up that has a sliding glass door multi-point keeper model 82-249. Can you tell me which one is the best fit for my ... (cont.)

Looking for parts handle specifically for a forever storm door sn 1927810 can u help ?

I have the inside handle only. I need the black SGDH-3 door handle. There is also a letter A in the part on the inside. Please help me find it so we may replace bad ones and have some in stock. Thank you, Fernando

I tried opening a left bathroom window that had not been open in years. Apparently I used too much force and snapped the bottom arm. I cannot find Vetter replacement parts on Amazon. Are there standard replacement parts for these operators?

Hi, I need to replace a window crank approximately 5 1/4 from left to right, the arm is approximately 8 inches when extended. Do you have a replacement? Picture attached. Thank you!

Hello - this broke off in an older casement window that I am replacing. The part is located on the frame slide of the window and plays a part when the arm is rolled out to open the window.

Our new home broke off sliding glass door handles for a Richmond American home 12 foot patio door. The home is a Richmond American Coral II model. It looks to be an easy replacement with two screws on each handle.

I need 4 rollers for each set of doors