Viewing all customer Discussions for:

Door & Window

I have a window that measures 58x32. There are 2 different size balances when I took the bottom sash out. I don't know which one is the correct size? In one of the pictures I measured from the bottom of the window to the top of the bottom sash. I also measured the width of the side jamb to make sur ... (cont.)

Looking for the whole inner workings of a window crank and casing with handle. Thank you!

This piece was bent and broke when I tried to straighten it. It is at the bottom of a single hung window and slides into the pivot foot. Also need to replace the spring on these "carefree" windows

These windows say Silver line on them, albeit upside-down. They open just fine, but when trying to close them the handles just pop out.

I tried before to give u pics of this to no avail. I hope these are better to describe what I need. Thank you

For Broyhill chest of drawers, end-to-end width 5 inches, looking for one complete assembly. Thank you.

I need replace tension spring rollers for few sliders. I found some that looked exactly like the product 84-031 however they won't fit due to the depth of the groove which is 3mmThe original wheels have a groove that is 5mm deep. Since these doors use both top and bottom tension rollers the 3mm dept ... (cont.)

I have looked at your parts and I have found ones that are close could you help?

I have sent you these following pictures to see how we can help me to finde the right handle for my door. They want to let me know that my door is a "Grisham", but I can't see the serial anywhere

Attached are pictures of balance channels i need one shows #28A the other 2810 NL BS. Do i get 28" series 385 balances? Please let me know asap so i can order and how fast can i get delivery to St Petersburg Florida

how do I determune which balance to get

I'm looking for an Andersen awning operator, part number 1521027. I can't find anything by that part number anymore. Is there another part number that would work?

Length 41/2 inches (not including the wheel ) wheel 1 1/4 Hight 1 ½ inch Have to retrofit 200 apartments

I'm looking at replacing many broken window balances used in vinyl double hung tilt in windows for my home. There are likely different sizes that I need since some windows are bigger than others. Can I get exact replacements or do I need an alternative balance? Also, the plastic anchor at the to ... (cont.)

Do you have these corners available ????

channel balance with 29D , 30" metal lengthwindow name is Harcar , need 8 each & 8 White top sash stops, ; S380-30 w/ 2940

Hello, I need to replace a no. of channel balances in my home. My home was built in 1997. I have removed the old balances from one window and would like to know if I can get replacements from you. These balances are marked '29 2 LP Caldwell'. There are other windows of different sizes that most l ... (cont.)

I have a Milestone non-tilt window that needs a new block&tackle balance. It measures 28"long, 9/16"wide at open channel side, 1/2"wide at back of channel, and depth of channel is 1/2". It has a 27C stamp as shown in the attached picture and the end connection as shown in the attached picture. I had ... (cont.)

The plastic mounting bracket has a center height adjuster hole that measures 11/64" ID. It may be possible to drill it out to 21/64". The question is what is the OD and height of the adjuster on the 84-74B stainless steel roller?

Hi, I am trying to find a replacement part for my broken astragal for my patio door. Its a 4 door configuration with 2 static and the middle two sliding left and right. The astragal on the right door allows the left door to lock in and keep the wind drafts out. As you can see there are some chips i ... (cont.)